BMW 2010 M6 Convertible Manual Do Proprietário

207

Switch on the device and allow to run for
approx. 3 minutes to fill wheel with sealant.
It is not important what inflation pressure
the tire has after filling.

Switch off device.

10.

Remove connecting hose from connection
of sealant bottle and tire valve.
Stow the M Mobility System in the vehicle
again.

Distributing sealant

Immediately drive approx. 2 miles/3 km so that
sealant is evenly distributed in tire.

Do not exceed a maximum speed of
35 mph/60 km/h. Do not drop below

12 mph/20 km/h if possible.

Producing tire inflation pressure

After approx. 2 miles/3 km, stop at suitable
location.

Screw compressor hose

9 directly onto tire

valve.

Insert connector

3 in lighter socket in vehi-

cle interior.

Correct tire inflation pressure to 29 psi/
200 kPa. With the ignition switched on:

Increase inflation pressure: switch on
device, position I. To check currently set
inflation pressure, briefly switch off
device.

Do not allow compressor to run
longer than 10 minutes, otherwise

the device will overheat and may be dam-
aged.

Reduce inflation pressure: press
button

8 or turn screw 8 on pressure

gauge.

If the inflation pressure is not held, drive
the vehicle again, refer to Distributing

sealant. Then repeat steps 1 to 4 once.
Using the M Mobility System can be ineffective
with tire damage from a size of approx. 0.16 in/
4 mm. Please contact the nearest BMW center,
refer to page

213

, or a workshop that works

according to BMW repair procedures with cor-

respondingly trained personnel if the tire can-
not be made ready for driving with the
M Mobility System.

The tire inflation pressure must be at least
29 psi/200 kPa. Otherwise do not con-

tinue driving.

Continue driving

Do not exceed the permissible maximum
speed of 50 mph/80 km/h, otherwise

accidents can occur.

Reinitialize the Flat Tire Monitor.
For details, refer to page

Have the defective tire and the sealant bottle of
the M Mobility System replaced as soon as
possible.

Changing wheels*

Safety precautions in the event of a flat
tire or wheel change: Park the vehicle as

far as possible from passing traffic and on solid
ground. Switch on the hazard warning flashers.
Apply the parking brake and shift into first gear
or reverse with the manual transmission, or
move the selector lever into a drive position with
the sequential transmission.
Have all vehicle occupants get out of the vehicle
and ensure that they remain outside the imme-
diate area in a safe place, such as behind a
guardrail.
If a warning triangle

or portable hazard warning

lamp

is required, set it up on the roadside at an

appropriate distance from the rear of the vehi-
cle. Comply with all safety guidelines and regu-
lations.
Change the wheel only on a level, firm surface
which is not slippery. The vehicle or the jack
could slip to the side if you attempt to raise the
vehicle on a soft or slippery surface such as
snow, ice, tiles, etc.
Position the jack on a firm support surface.
Do not use a wooden block or similar object as a
support base for the jack, as this would prevent
it from extending to its full support height and
reduce its load-carrying capacity.
To avoid serious or fatal injury: never lie under