Brocade Communications Systems Switch 53-1001762-01 Manual Do Utilizador

debug lacp

6

debug lacp 

Enables debugging for the Link Aggregation Control Protocol (LACP).

Synopsis

debug lacp {all | cli | event | nsm | pdu {rx {all | interface tengigabitethernet slot/port} | tx {all | 
interface tengigabitethernet slot/port} }| sync | timer | trace level number}

no debug lacp {all | cli | event | nsm | pdu {rx {all | interface tengigabitethernet slot/port} | tx { all 
| interface tengigabitethernet slot/port} }| sync | timer | trace level number}

Operands

all    

Turns on all debugging.

cli    

Turns on command line interface debugging.

event 

Turns on event debugging.

nsm    

Turns on Network Services Module (NSM) debugging.

pdu    

Turns on PDU debugging.

rx all 

Turns on debugging for received LACP packets on all interfaces.

rx interface

Turns on debugging for received LACP packets on the specified
interface.

interface tengigabitethernet 

Specifies the 10 Gbps Ethernet interface.

Specifies the slot number.

Specifies the port number.

tx all

Turns on debugging for transmitted LACP packets on all interfaces.

tx interface

Turns on debugging for transmitted LACP packets on the specified interface.

interface tengigabitethernet 

Specifies the 10 Gbps Ethernet interface.

Specifies the slot number.

Specifies the port number.

sync   

Turns on debugging for LACP sync transitions.

timer 

Turns on debugging for LACP timers.

trace level number Specifies the trace level number. The range of valid values is 1-7. 

Defaults

By default, debugging is not turned on.

Command

Modes

Privileged EXEC mode

Description

Use this command to enable debugging for Link Aggregation Control Protocol (LACP). Use the no 
debug command to disable debugging.

Usage

Guidelines

To display debug outputs on a specific cmsh session, use the terminal monitor command.