Weider PRO 9635 SYSTEM WESY9635 Manual Do Proprietário
5
ASSEMBLY
1
8
11
51
27
1
4
3
1
51
5
1.
Before beginning assembly, be sure that
you have read and understand the infor-
mation in the box above.
you have read and understand the infor-
mation in the box above.
Locate and open the parts bag labeled
“FRAME ASSEMBLY.”
“FRAME ASSEMBLY.”
Press two 2” Square Outer Caps (51) onto
the indicated locations on the Stabilizer (5).
Press a 2” Square Inner Cap (27) into the
end of the Base (4).
the indicated locations on the Stabilizer (5).
Press a 2” Square Inner Cap (27) into the
end of the Base (4).
Insert six 5/16” x 2 1/2” Carriage Bolts (1) up
through the Stabilizer (5). Insert two 5/16” x
2 1/2” Carriage Bolts up through the Base
(4).
through the Stabilizer (5). Insert two 5/16” x
2 1/2” Carriage Bolts up through the Base
(4).
Attach the Base (4) to the Stabilizer (5) with
two 5/16” x 2 3/4” Bolts (11), two 5/16” Flat
Washers (8), and two 5/16” Nylon Locknuts
(3).
two 5/16” x 2 3/4” Bolts (11), two 5/16” Flat
Washers (8), and two 5/16” Nylon Locknuts
(3).
Do not tighten the Nylon Locknuts
yet.
FRAME
ASSEMBL
Y
Before beginning assembly, carefully read the
following information and instructions:
following information and instructions:
• Place all parts of the PRO 9635 in a cleared area
and remove the packing materials; do not dis-
pose of the packing materials until assembly is
completed.
pose of the packing materials until assembly is
completed.
• The assembly is broken into five stages: 1) frame
assembly, 2) press and butterfly arm assembly,
3) cable and pulley assembly, 4) seat and back-
rest assembly, and 5) VKR assembly. The hard-
ware for each stage is packaged separately.
3) cable and pulley assembly, 4) seat and back-
rest assembly, and 5) VKR assembly. The hard-
ware for each stage is packaged separately.
• Wait until you begin each assembly stage to open
the parts bag labeled for that assembly stage.
• For help identifying the small parts used in
assembly,
use the PART IDENTIFICATION
CHART located in the center of this manual.
Note: Some small parts may have been pre-
attached for shipping. If a part is not in the parts
bag, check to see if it has been pre-attached.
Note: Some small parts may have been pre-
attached for shipping. If a part is not in the parts
bag, check to see if it has been pre-attached.
• As you assemble the PRO 9635 be sure that all
parts are oriented as shown in the drawings.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
THE FOLLOWING TOOLS (NOT INCLUDED) ARE
REQUIRED FOR ASSEMBLY:
REQUIRED FOR ASSEMBLY:
• Two (2) adjustable wrenches
• One (1) standard screwdriver
• One (1) phillips screwdriver
• One (1) rubber mallet
• Lubricant, such as grease or petroleum jelly,
and soapy water will also be needed.
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches, or a set of ratchet wrenches.
following tools: A socket set, a set of open-end or
closed-end wrenches, or a set of ratchet wrenches.
1