WHP Wireless DL360 Manual Do Utilizador

4.  Press the Power On/Standby button to place the server in standby mode. 

When the server activates standby power mode, the system power LED 
changes to amber. 

5.  If the server is installed in a rack, locate the server by identifying the 

illuminated rear UID LED button. 

6.  Disconnect the power cords. 

The system is now without power. 

 

NOTE:  If the optional cable management arm option is installed, you 
can extend the server without powering down the server or 
disconnecting peripheral cables and power cords. These steps are only 
necessary with the standard cable management solution. 

1.  Power down the server ("Powering Down the Server" on page 

2.  Disconnect all peripheral cables and power cords from the server rear panel. 

3.  Loosen the thumbscrews that secure the server faceplate to the front of the 

rack. 

4.  Extend the server on the rack rails until the server rail-release latches engage. 

  WARNING:  To reduce the risk of personal injury or 

equipment damage, be sure that the rack is adequately stabilized 
before extending a component from the rack. 

  WARNING:  To reduce the risk of personal injury, be 

careful when pressing the server rail-release latches and sliding 
the server into the rack. The sliding rails could pinch your fingers. 

5.  After performing the installation or maintenance procedure, slide the server 

back into the rack: 

a.  Press the server rail-release latches and slide the server fully into rack.