WHP Wireless DL360 Manual Do Utilizador

1.  Place the access panel on top of the server with the hood latch open. Allow 

the panel to extend past the rear of the server approximately 8 mm (0.2 in). 

2.  Engage the anchoring pin with the corresponding hole in the latch. 

3.  Push down on the hood latch. The access panel slides to a closed position. 

 

  CAUTION:  To prevent damage to the server or expansion 

boards, power down the server and remove all AC power cords before 
removing or installing the PCI riser cage. 

1.  Power down the server ("Powering Down the Server" on page 

2.  Extend the server from the rack, if applicable ("Extending the Server from 

the Rack" on page 

3.  Remove the access panel ("Removing the Access Panel" on page 

4.  Remove the PCI riser board assembly: 

a.  Disconnect any internal or external cables connected to any existing 

expansion boards. 

b.  Loosen the four PCI riser board assembly thumbscrews.