WHP Wireless DL360 Manual Do Utilizador

8.  Install the expansion board into the slot until it seats firmly. 

 

IMPORTANT:  If the expansion board ships with an extender bracket, 
remove it from the expansion board before inserting the board into the 
expansion slot of the PCI riser board assembly. 

IMPORTANT:  Be sure that all DIMM slot latches are closed to provide 
adequate clearance before installing the PCI riser board assembly with 
a half-length expansion board. 

9.  Install the PCI riser board assembly ("Installing PCI Riser Board Assembly" 

IMPORTANT:  The server will not power up if the PCI riser board 
assembly is not seated properly. 

NOTE:  The same procedures apply for installing an expansion board in 
PCI expansion slot 1. 

 

1.  Power down the server ("Powering Down the Server" on page 

2.  Extend the server from the rack, if applicable ("Extending the Server from 

the Rack" on page 

3.  Remove the access panel ("Removing the Access Panel" on page 

4.  Remove the PCI riser board assembly.