WHP Wireless DL360 Manual Do Utilizador

The auto-configuration process automatically runs when you boot the server for 
the first time. During the power-up sequence, the system ROM automatically 
configures the entire system without needing any intervention. During this 
process, the ORCA utility, in most cases, automatically configures the array to a 
default setting based on the number of drives connected to the server. 

NOTE:  The server may not support all the following examples. 

NOTE:  If the boot drive is not empty or has been written to in the past, 
ORCA does not automatically configure the array. You must run ORCA 
to configure the array settings. 

1 1 

RAID 

0 

2 2 

RAID 

1 

3, 4, 5, or 6 

3, 4, 5, or 6 

RAID 5 

More than 6 

0 

None 

 

To change any ORCA default settings and override the auto-configuration 
process, press the F8 key when prompted. 

By default, the auto-configuration process configures the system for the English 
language. To change any default settings in the auto-configuration process, such 
as the settings for language, operating system, and primary boot controller, 
execute RBSU by pressing the F9 key when prompted. After the settings are 
selected, exit RBSU and allow the server to reboot automatically. 

For more information, refer to the HP ROM-Based Setup Utility User Guide on 
the Documentation CD or the HP website 
(