WHP Wireless DL360 Manual Do Utilizador

HP recommends using DNS/DHCP with iLO to simplify installation. If 
DNS/DHCP cannot be used, use the following procedure to disable DNS/DHCP 
and to configure the IP address and the subnet mask: 

1.  Restart or power up the server. 

2. Press 

the 

F8 key when prompted during POST. The iLO RBSU runs. 

3.  Enter a valid iLO user ID and password with the appropriate iLO privileges 

(Administer User Accounts, Configure iLO Settings). Default account 
information is located on the iLO Default Network Settings tag. 

4. Select 

Network, DNS/DHCP, press the Enter key, and then select DHCP 

Enable. Press the spacebar to turn off DHCP. Be sure that DHCP Enable is 
set to Off and save the changes. 

5. Select 

Network, NIC and TCP/IP, press the Enter key, and type the 

appropriate information in the IP Address, Subnet Mask, and Gateway IP 
Address fields. 

6.  Save the changes. The iLO system automatically resets to use the new setup 

when you exit iLO RBSU. 

 

  CAUTION:  Perform a backup before running the System 

Erase Utility. The utility sets the system to its original factory state, 
deletes the current hardware configuration information, including array 
setup and disk partitioning, and erases all connected hard drives 
completely. Refer to the instructions for using this utility. 

Run the Erase Utility if you need to erase the system for the following reasons: 

• 

You want to install a new operating system on a server with an existing 
operating system. 

• 

You want to change the operating system selection. 

• 

You encounter a failure-causing error during the SmartStart installation. 

• 

You encounter an error when completing the steps of a factory-installed 
operating system installation.