Procom AL500HYLA Manual Do Utilizador

                            5                                                   AL058-01 

 

8.  Set the top panel in place on the columns and 

secure with M4 × 10 screws provided. Do not 

tighten at this time. (See FIG.8) 

 

12. From the outer side, use M5

× 10 screws to 

fasten the fixing hoop on the right and left support. 

Fasten the other side of the fixing hoop after the   

cylinder is in place.    (See FIG.11)

 

Note:  The installer must supply an external regulator 

with a hose (with 5/8” nut at one end, and a regulator 

at the other end) and a 20# Vertical Acme with OPD 

LP cylinder. 

1. Turn the door knob clockwise and open heater 

door. 

2. Remove dustproof wrap from regulator. 

3. Set cylinder flat on base compartment (See FIG.12) 

4. Connect regulator with cylinder. Tighten with care. 

Do not over-pressurize the valve. 

5. Before opening gas supply valve, make sure 

control knob is in the OFF position. Open gas 

supply valve. Apply a mixture of liquid soap and 

water to all joints. Do not use an open flame. 

Bubbles forming show a leak.  Check all 

connections for leaks immediately. 

9.  Attach the screens to columns with M4 × 10 

screws provided. Do not tighten at this time. (See 

FIG.9) 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

10. Tighten the screws of step 8,9,10 to finish 

installation. 

11. Attach the handle to the middle base with 2 hex 

head screws provided. (See FIG.10)