Microboards Technology PF-Pro Disc Printer Manual Do Utilizador

 

 

 

This page shows the Firmware version and Serial 
Number of the PF-Pro Disc Printer. 

Clicking the Print Configuration Page button will print out 
a test disc. 

 

 

 

The Clean page allows you to run a cleaning cycle on 
the ink cartridge. 

Click the Clean button once a disc has been loaded into 
the input hopper.  If the resulting disc shows streaks 
similar to those shown in the image on this page, you 
may need to run the Clean utility again. 

If, after several cleaning attempts, the printed images continue to show streaks of color, you may 
need to manually clean the printheads.  Follow the procedure below exactly to clean the printheads.  
Not following these steps could result in damaged printheads. 

1.  Remove the printheads from the carriage (please see 

Installing/Replacing Printheads, page 7). 

2.  Use ionized water to lightly dampen a lint-free cloth 
3.  Place the cloth on a level surface 
4.  Holding the printhead with the bottom of the printhead resting 

lightly on the cloth, gently pull the printhead towards you 
along the direction of the long axis of the printhead, as shown 
to the right.   

5.  If the printhead does not leave two solid lines of color, one for 

each color in the printhead, move the printhead to a clean 
area on the cloth and repeat step 4. 

6.  Carefully replace the printhead in the PF-Pro Disc Printer 

once the heads have been cleaned. 

If you do not follow the above procedure exactly, you could damage your printheads!