Infortrend EONSTOR A16E-G2130-4 Manual Do Utilizador

Chapter 5: Subsystem Maintenance and Upgrading  

 Step 4. 

Install the replacement module by aligning it with the module bay 

on the PSU module and gently lowering it into. The fan outlet 

should be aligned with the PSU faceplate and that the side with 

screw holes should be facing up.   

 

Do this with a precisely vertical motion so that the cooling 

module’s connector can correctly mate with the connector in the 

module bay.   

 Step 5. 

Secure the module by fastening the screws you previously 

removed.   

 Step 6. 

Reinstall the PSU module into chassis.  When powered on, check 

if the cooling fan LEDs are lit. If not, that means your cooling fans 

are operating properly.   

 

•  Hot-swappable drive trays: The drive trays are all hot-swappable. A disk drive 

failure can be corrected online.   

•  Handles: If the failed hard drive is behind either the left or right front handle, 

unfold the handles to open the front access to the drive trays. 

 

Figure  5--14: Open the Front Handles  

 Step 1. 

Open flap: Once the front flap on the drive tray has been opened, the 

drive tray must be removed from the subsystem. Failure to remove 

the drive tray from the subsystem after the front flap has been 

opened may cause data errors. 

 Step 2. 

Slowly remove a faulty drive: When removing a drive tray from the 

subsystem, 

Replacing a Failed Hard Drive 

 

5-19