Grindmaster P400ESHP Guia Do Utilizador

Operation and Instruction Man u al

For Models P300E, P400E, P400ESHP, RAP300E,

RAP400E, RAPS300E, RAPS400E

See rough-in drawings in this manual for di men sions and lo ca tions of
electric and water input.  

1)  Remove the brewer from the packing material and attach its legs.

2)  Position the brewer on a strong, stable table or counter.  Check

the level front to back and side to side.  Adjust the legs to the cor-
rect level.

IMPORTANT:
THE PERSON INSTALLING THIS APPLIANCE IS RESPONSIBLE  
FOR ENSURING THAT ELECTRIC AND WATER CONNECTIONS 
MEET THE RE QUIRE MENTS OF THE  NATIONAL ELECTRIC 
CODE,  NATIONAL PLUMBING CODE, AND ANY LOCAL 
ORDINANCES.

The electric and water hook-up locations are behind the front pan el. 
Re move the four screws fastening this panel for access to these 
con nec tions.

Installation and Start-up ....................................... 1-2
Warning Labels ...........................................................3 
Operation .......................................................... 4
Adjustments ........................................................ 5-8
Care and Cleaning ............................................... 9-10
Service ............................................................... 10-11
Troubleshooting

Filling Problems ....................................... 12
Heating Problems ................................. 13
Brewing Problems ................................ 14

Parts Illustrations

Models P300E & P400E ....................... 15
Model P400ESHP .....................................16
Model RAP400E .....................................  17
Model RAPS400E ................................... 18
VSB-400................................................ 19
Shuttle CS-LL ..........................................  20

Rough-In Drawings

Model P300........................................................... 21
Model P400 & P400ESHP ...................... 22
Model RAP300 ......................................... 23
Model RAP400 ........................................ 24
Model RAPS300 ....................................... 25
Model RAPS400 ..................................... 26
VSB-300 .................................................. 27
VSB-400 ................................................ 28

Wiring Diagrams

P300E/P400E with 1 Batch Timer ......... 29
P300E/P400E with 2 Batch Timer........ 30
RAP300E/RAP400E................................31
RAPS300E/RAPS400E........................32
P400ESHP ...........................................33
Drawing #091-548 .................................34
Drawing #091-182 .....................................35

1)  The water line may enter through holes on the rear or the bottom of the brewer.  Use the right hand opening for water.
2)  Use 3/8" copper or flexible water line to prevent strain.  Do not use low temperature plastic tubing. The connection 

to the fill valve is 3/8" flare.

3)  Water line pressure must be from 30 to 70 psi.
4)  Hot (up to 160°F) or cold water may be used.  Hot water offers faster recovery between brews.
5)  Install a shut-off valve near the brewer.
6)  Installing a filtering system can improve the taste of brewed coffee and extend the life of the brewer.  If your water 

has high calcium (lime), chlorine, or iron content, this is especially important.  The filter should be the lime inhibiting 
type if cold water is used. Contact your local water treatment professional regarding the type of filter you should use 
based on water quality and volume of water used. 

© Grindmaster Corporation, 1998
PRINTED IN U.S.A.

0307 FORM # AM-309-08
Part # 090-077

