Grindmaster P400ESHP Guia Do Utilizador

1)

The electric ratings for your brewer are printed on its nameplate.  Typical electric ratings
are:
P300, P400, RAP300, RAP400
Optional

120/208V, 3.8kW, 18A or 120/240V  5.0kW, 21A, 1 phase

Standard

120/208V, 5.0kW, 24A or 120/240V  6.6kW, 28A, 1 phase

RAPS300, RAPS400
Standard

120/208V, 4.4KW, 21A or 120/240V, 5.6KW 24A, 1 phase

P400ESHP
Standard

440V, 12.5KW, 16.3A, 3 phase WYE

If the brewer includes the three heater tank option C21A, the ratings will be different.  Always
see the nameplate for correct ratings.

2)

The brewer should be connected to its own circuit with a fused disconnect switch or a 
circuit breaker near the brewer.

3)

Attach the appropriately sized cord to the brewer with a cord grip for the 1 1/2" electric input
opening.  The cord may enter through the rear or bottom on the left side of the brewer.  Use
an oil resistant cord such as type SO, SOO, SAO, STOO, SEO, SJO, SJOO, SJTO, SJTOO,
SJEO, HSO, HSOO, HSJO, or HSJOO.  Alternatively, flexible conduit and type THHN wires
may be used.  Use only copper conductors.

4)

Standard connection is 1 phase 3 wire.  Connect the two lines to L1 and L2 on the terminal
block.  If the brewer is wired for three phase, a lug, L3, is provided on the terminal block.  A
neutral line must be connected to the N terminal.

5)

The body of the brewer must be grounded.  A ground lug is provided for this purpose.

1)

Turn on the water supply to the brewer.  Check for leaks.

2)

Turn on the electric supply.  The brewer will begin to fill.

3)

Replace the front access panel.

4)

Once the brewer is full, it will take 15 to 35 minutes to heat.  The water hot light will turn on
when up to temperature.

5)

Insert the brew baskets and place a shuttle or airpot under the baskets.  Brew at least one
batch from each side.  Check the level in the container to be sure the brew volume is correct.
Remember that when using coffee, the level will be lower.  Do this for both batch sizes when
provided.  The water must be hot to check the levels.  If adjustments are needed, see the 
adjustments section of this manual. 

