Everpure 2001 Manual Do Utilizador

 

Page 8 of 60 

July 6, 2001 

Suprema 2001 - Operation & Service 

 

a)  Install the carafe tray as illustrated below. Once done, install the cup stand 

on top of the carafe tray. 

b)  Install the bezel by first inserting the tabs on bottom if it into the notches 

on the door. Push the top of the bezel into the door until it clips in place. 

 
 
 
 
 
 
 
 
 
 
 
 

a)  Apply Teflon tape to a 3/8" plumbing fitting. If a 1/4" line is being used, 

you will then need a 1/4 x 3/8" fitting. 

♦

  Teflon tape should be applied in a clockwise 

b)  Thread the fitting into the inlet valve at the back of the 

coffee maker and tighten with a wrench. 

d)  Connect the water line to the fitting. 

e)  Turn the water on at the source. 

f)  Plug the coffee maker into the wall outlet. 

a)  The main power switch is found on the back of the coffee maker. 

b)  When the power is switched "

", you should hear the coffee maker 

filling with water. 

c)  Check the plumbing for leaks and correct them, if necessary. 

d)  Check the display for any messages, and take the indicated action. 

a)  Open the front door of the coffee maker. 

b)  Lift the lid on top of the coffee maker. 

c)  One section of the ingredient dispenser is larger than the other. The large 

section is for the coffee that is expected to have higher consumption. The 
smaller is for decaffeinated or lower consumption blends. 

d)  Fill the ingredient dispensers by pouring coffee through the opening in the 

lid. 

!

        

 

◄ 

Install the carafe tray 
(and grill) and the cup 
stand (and grill). 

 
 
 

► 

Install the pre-

assembled graphics 

(and pricing) bezel.