Enviro EG 33 Manual Do Utilizador
INSTALLATION OF LOGSET and EMBERS
INSTALLING THE GLOWING EMBERS and LOGSET
A bag of ceramic fiber embers is provided for use on the
front burner ember tray.
A bag of ceramic fiber embers is provided for use on the
front burner ember tray.
CAUTION:
Use only the type of ember material supplied
with this appliance. Due to the irregular size of the ember
material there may be more than required. Use only a
single layer. Do not pile embers. The use of other foreign
materials on the burners may create dangerous conditions.
If over time, through cleaning and servicing, these embers
require replacement, contact your nearest ENVIROGAS
dealer for replacement embers.
1. Carefully remove log from unit. Check to ensure there
material there may be more than required. Use only a
single layer. Do not pile embers. The use of other foreign
materials on the burners may create dangerous conditions.
If over time, through cleaning and servicing, these embers
require replacement, contact your nearest ENVIROGAS
dealer for replacement embers.
1. Carefully remove log from unit. Check to ensure there
is no damage. It is very important to install this log in
its proper position to insure safe, optimum operating
conditions.
its proper position to insure safe, optimum operating
conditions.
2. Place the log set into the firebox with the burnt area
forward. Locate the log by seating it down onto the
burner tray supports
burner tray supports
3. Gently remove the ember material from the plastic
bag. Spread a single layer loosely across the rear
ember tray. Do not allow any embers to rest against
pilot assembly.
ember tray. Do not allow any embers to rest against
pilot assembly.
4. Spread ember pieces in a single layer evenly across
the front burner ember tray, Place a single layer of
embers on top of the front burner.
embers on top of the front burner.
5. Carefully avoid any clumping or large build-ups. Do
not pack down, leave embers loose
6. Upon the first light up, watch for ignition to all burner
ports. If a long delay is noted:
First, wait for the appliance to cool down
•
•
Open the front door of the appliance.
•
Check to carefully reposition the embers making
sure that burner ports are not plugged solid or
blocked
sure that burner ports are not plugged solid or
blocked
CAUTION: NEVER OPERATE THIS APPLIANCE WITH
THE DOOR REMOVED
REMOVING AND INSTALLING THE BRICK PANELS
Open the door. Remove the log set.
STEEL PANEL: Undo the two screws located in the top
two corners of the firebox. Tilt forward at top corners and
pull out. Installation is the reverse.
Open the door. Remove the log set.
STEEL PANEL: Undo the two screws located in the top
two corners of the firebox. Tilt forward at top corners and
pull out. Installation is the reverse.
OPTIONAL CERAMIC PANELS
Remove the burner top from the firebox, this will prevent
possible damage to the ceramic panels.
Place the back panel on the rear support ledge making
sure that the panel is centered on the back of the firebox.
Install side panels into firebox insuring that the rear edge
of the side panel supports the rear panel from falling
forward. Install the two retaining clips (one on each side) in
the front upper corner in the holes provided.
Remove the burner top from the firebox, this will prevent
possible damage to the ceramic panels.
Place the back panel on the rear support ledge making
sure that the panel is centered on the back of the firebox.
Install side panels into firebox insuring that the rear edge
of the side panel supports the rear panel from falling
forward. Install the two retaining clips (one on each side) in
the front upper corner in the holes provided.
14