Avaya Bogen Universal Paging Access Module Instrução De Instalação
[14]
Station Port / Centrex Connections (cont’d)
5.
Connect "Tip" of station port to T terminal of UPAM (see Figure 5).
6.
Connect "Ring" of station port to R terminal of UPAM.
7.
Connect PT and PR terminals on UPAM to the paging system, as shown in Section
3. Connect the N.O. and COM terminals to the control pair of the amplifier, if
required. Also, connect any background music source to the BGM IN jack on the
UPAM.
3. Connect the N.O. and COM terminals to the control pair of the amplifier, if
required. Also, connect any background music source to the BGM IN jack on the
UPAM.
8.
Set the Default timer by calling the system and measuring the length of time before
the call is disconnected. Adjust the PAGING TIME control and repeat and readjust
as necessary.
the call is disconnected. Adjust the PAGING TIME control and repeat and readjust
as necessary.
9.
Call the system and set the page volume using the paging system's amplifier
volume control.
volume control.
10.
Hang up and adjust the background music level using UPAM BGM VOL control.
11.
Call the system and adjust the volume of the pre-announce/confirmation tone
volume using the TONE VOL control. (Note: If the tone can be heard over the
paging system but is shortened or if it is absent in the handset, it may be necessary
to increase the length of ring before the UPAM answers. See Ring Delay (page 16).
volume using the TONE VOL control. (Note: If the tone can be heard over the
paging system but is shortened or if it is absent in the handset, it may be necessary
to increase the length of ring before the UPAM answers. See Ring Delay (page 16).
12.
If the VOX disconnect is to be used, adjust the VOX delay. To do this, make sure
mode switch #5 is in the ON position and proceed as follows:
mode switch #5 is in the ON position and proceed as follows:
• Rotate VOX DELAY control approximately 1/2 way.
• Call the system and, after the pre-announce or confirmation tone, speak into the
telephone for 5 seconds at a normal voice level, then stop and evaluate the time
delay before disconnection. If it is not sufficiently long to allow for pauses in
phrases without disconnecting, readjust VOX DELAY and repeat this step.
telephone for 5 seconds at a normal voice level, then stop and evaluate the time
delay before disconnection. If it is not sufficiently long to allow for pauses in
phrases without disconnecting, readjust VOX DELAY and repeat this step.
NOTE:
The minimum VOX delay is approximately 2 seconds. On some systems, which
return a reorder tone to the called party within 2 seconds of hang up, VOX DELAY
cannot be used.
return a reorder tone to the called party within 2 seconds of hang up, VOX DELAY
cannot be used.