ACS Marine Sanitation System A0565547 Manual Do Utilizador
4 –Pump 38-Station Controllers
Chapter 4: Operation
30 of 44
Activating and Stopping Priority Convey for a Station
Note:
Before activating priority convey, make sure that all other stations using the same
pump have adequate material in reserve to continue operation. No material will be
conveyed to these stations during priority convey.
pump have adequate material in reserve to continue operation. No material will be
conveyed to these stations during priority convey.
If you want the controller to fill a specific station with material immediately, you can activate
“priority convey” for that station. When you do so, the controller temporarily dedicates the
station’s pump to it, ignoring demands from other stations assigned to that pump. Once the
chosen station is full, normal operation resumes.
“priority convey” for that station. When you do so, the controller temporarily dedicates the
station’s pump to it, ignoring demands from other stations assigned to that pump. Once the
chosen station is full, normal operation resumes.
You can also use this feature to give one station a “head start” by conveying a few loads to it
and then stopping the priority convey.
and then stopping the priority convey.
No more than one station for a given pump can be in “priority convey” at once. To activate
priority convey, complete the following steps:
priority convey, complete the following steps:
1. Go to the “Station Operator” by touching and holding a station icon, or go to the
“Station Setup” screen.
2. Touch PRIORITY CONVEY ACTIVATE. The button changes to PRIORITY
CONVEY ACTIVE until the station’s demand has been satisfied (or you stop the
priority convey). The controller begins filling the chosen station only (after finishing
any conveying already in progress).
priority convey). The controller begins filling the chosen station only (after finishing
any conveying already in progress).
3. To stop a priority convey before the station is completely full, Touch the PRIORITY
CONVEY ACTIVE button. The button changes to PRIORITY CONVEY
ACTIVATE. The controller finishes the current convey, if any, and resumes normal
operation.
ACTIVATE. The controller finishes the current convey, if any, and resumes normal
operation.
Navigating among the “Station Operator” Screens
The controls at the top of the screen enable you to move among the “Station Operator”
screens:
The controls at the top of the screen enable you to move among the “Station Operator”
screens:
• To display the screen for the next lower-numbered station (for example, to move from
the screen for Station 15 to the screen for Station 14), touch PREVIOUS.
• To display the screen for the next higher-numbered station (for example, to move from
the screen for Station 15 to the screen for Station 16), touch Next.
• To exit to the “Station Status” (or “Pump Status”) screen, touch STATION STATUS
(or PUMP STATUS).