ACS Marine Sanitation System A0565547 Manual Do Utilizador
4 –Pump 38-Station Controllers
Chapter 4: Operation
31 of 44
4-3 Adjusting Advanced Settings
This section describes the procedures carried out during operation that are normally reserved
for setup personnel. These procedures require use of the setup password (if your facility has
defined one). The procedure for logging on and off with the setup password is the same as for
logging on with the operator password; see p. 26 for step-by-step instructions for logging on
and off.
for setup personnel. These procedures require use of the setup password (if your facility has
defined one). The procedure for logging on and off with the setup password is the same as for
logging on with the operator password; see p. 26 for step-by-step instructions for logging on
and off.
Reviewing and Resetting a Pump Hour Meter
The controller keeps two meters for the length of time a pump has run. One, like a car’s
odometer, keeps a running total and cannot be reset. The other, like a car’s trip odometer,
counts the running time since the last reset.
The controller keeps two meters for the length of time a pump has run. One, like a car’s
odometer, keeps a running total and cannot be reset. The other, like a car’s trip odometer,
counts the running time since the last reset.
To review and reset the hour meter, complete the following steps:
1. At any screen, touch the PUMP STATUS button.
2.
Touch and hold the icon for the pump. The “Pump Setup” screen opens.
Figure 13: Pump Setup Screen
The box labeled x Hours shows the running time since the last reset. The box labeled total x
Hours shows total running time.
Hours shows total running time.
To reset the resettable meter, touch Hour Meter Reset. The time above x Hours changes to
0.
0.