Husqvarna DXR-310 Manual Do Utilizador

•  The electric motor is started by pressing the start 

button.

•  If several machines are used at the same workplace 

there is a risk of mixing up the remote controls.

Press the horn to see which machine is connected 
to the remote control. The machine will beep 
and fl ash three times. Do not activate the remote 
control before you have ensured that the correct 
machine is being operated.

•  To activate the remote control’s operating func-

tions press the left button on the right joystick. The 
remote control is now in work mode. The light emit-
ting diode on the remote control has a permanent 
blue light.

•  If no command is given within three seconds the 

operating functions are locked. To return to work 
mode, press the left button on the right joystick.

•  Manoeuvre the arm system down and allow it to 

rest against the ground.

•  Put all controls into neutral position.

•  Press the stop button.

•  Put the main switch into the OFF position (O).

It can be benefi cial to carry out the daily inspection 
after fi nishing work. Detecting damage in time can 
prevent a shutdown on the following day.

The following points should be checked when working 
at a new site and every morning before starting:

•  Carrying out daily inspections.

•  Examine the machine for transport damage.

•  Check that the machine’s safety features are intact. 

Refer to ’The machine’s safety features” in the 
’General working instructions” chapter.

•  Check that the power cable and operating cables 

are intact and correctly dimensioned.

•  Check that the mains voltage is compatible with 

the machine and that the correct fuses are used.

•  Always connect the machine through an earth-fault 

breaker with personal protection, i.e. an earth fault 
circuit breaker that trips at an earth fault of 30 mA.

•  Check that the emergency stop or machine stop 

button are not pressed by turning them clockwise.

•  Check that no tools or other objects have been left 

lying on the machine.

•  Connect the machine to a 3 phase power supply.

•  Turn on the main switch on the machine.

•  Turn the switch to the ON position (I). In this posi-

tion the remote control is supplied with current. 
The light emitting diode on the remote control 
fl ashes rapidly with a blue light when it is searching 
for contact. When it fl ashes with a longer interval 
the machine is in standby mode.

•  If a function is not working or needs attention, an 

error message appears on the display in conjunc-
tion with start-up. Refer to ’Error messages” in the 
’Trouble shooting” section.

English - 

25