BMW 2010 Z4 sDrive30i Manual Do Proprietário
83
Green
The tire inflation pressure corresponds to the
established target value.
"TPM active" appears on the Control Display.
established target value.
"TPM active" appears on the Control Display.
One wheel yellow
There is a flat tire or substantial loss of tire pres-
sure in the indicated tire. A message appears on
the Control Display.
sure in the indicated tire. A message appears on
the Control Display.
All wheels yellow
There is a flat tire or substantial loss of tire pres-
sure in several tires. A message appears on the
Control Display.
sure in several tires. A message appears on the
Control Display.
Gray
The system cannot detect a puncture.
Possible reasons for this:
Possible reasons for this:
>
TPM is being reset
>
Temporary malfunction caused by systems
or devices using the same radio frequency
or devices using the same radio frequency
>
Malfunction
Resetting the system
Each time a tire inflation pressure has
been corrected or a wheel or tire has been
been corrected or a wheel or tire has been
changed, reset the system.
<
1.
Press the button
The start menu is opened.
2.
"Vehicle Info"
3.
"Vehicle status"
4.
"Reset TPM"
5.
Start the engine, but do not start driving.
6.
Start the initialization using "Reset TPM".
7.
Start to drive.
The tires are shown in gray and "Resetting
TPM..." is displayed.
The tires are shown in gray and "Resetting
TPM..." is displayed.
After driving a few minutes, the set inflation
pressures in the tires are accepted as the target
values to be monitored. The system reset is
completed during your drive, and can be inter-
rupted at any time. When driving resumes, the
reset is continued automatically. On the Control
Display, the tires are shown in green and "TPM
active" is displayed again.
pressures in the tires are accepted as the target
values to be monitored. The system reset is
completed during your drive, and can be inter-
rupted at any time. When driving resumes, the
reset is continued automatically. On the Control
Display, the tires are shown in green and "TPM
active" is displayed again.
If a flat tire is detected while the system is
resetting and determining the inflation
resetting and determining the inflation
pressures, all tires on the Control Display are
displayed in yellow. The message "Low tire!" is
shown.
displayed in yellow. The message "Low tire!" is
shown.
<
Message for low tire inflation pressure
The warning lamps come on in yellow
and red. A message appears on the
Control Display. In addition, a signal
sounds. There is a flat tire or substan-
and red. A message appears on the
Control Display. In addition, a signal
sounds. There is a flat tire or substan-
tial loss of tire pressure.
1.
Cautiously reduce speed to below 50 mph/
80 km/h. Avoid sudden braking and steer-
ing maneuvers. Do not exceed a speed of
50 mph/80 km/h.
80 km/h. Avoid sudden braking and steer-
ing maneuvers. Do not exceed a speed of
50 mph/80 km/h.
If the car is not equipped with run-flat
tires, refer to page
tires, refer to page
, the standard
equipment by design, do not continue driv-
ing. Otherwise, a severe accident could
result after a tire puncture if you continue
driving.
ing. Otherwise, a severe accident could
result after a tire puncture if you continue
driving.
<
2.
In the event of complete pressure loss,
0 psi/0 kPa, you can estimate the possible
distance for continued driving on the basis
of the following guidelines:
0 psi/0 kPa, you can estimate the possible
distance for continued driving on the basis
of the following guidelines:
>
With a light load:
1 person without luggage:
approx. 155 miles/250 km
1 person without luggage:
approx. 155 miles/250 km
Online Edition for Part no. 01 41 2 602 883 - © 08/09 BMW AG