BMW 2006 760Li Sedan Manual Do Proprietário

 111

The integrated universal remote control can 
replace as many as three hand-held transmit-
ters for various remote-controlled accessories, 
such as door openers and house alarm sys-
tems. The integrated universal remote control 
registers and stores signals from the original 
hand-held transmitters.
The signal of an original hand-held transmitter 
can be programmed into one of the three mem-
ory buttons

1. Then the respective devices can 

be actuated using the programmed memory 
buttons. The LED

2 flashes to confirm trans-

mission of the signal.
Should you sell your vehicle one day, be sure to 
delete the stored programs beforehand for your 
security, refer to page

To prevent possible damage or injury, 
during programming or before each use 

of the programmed device by the integrated 
universal remote control, always inspect the 
immediate area to make certain that no people, 
animals or objects are within the swiveling and 
movement range of the device. Also, comply 
with the safety precautions of the original hand-
held transmitter.

<

If you see this symbol on the packaging 
or in the manual supplied with the orig-
inal hand-held transmitter, it is safe to 

assume that it is compatible with the integrated 
universal remote control.
If you have additional questions, please contact 
your BMW center or call: 1-800-355-3515.
Information is also provided on the Internet at: 
www.bmwusa.com or 
www.homelink.com. 
HomeLink is a registered trademark of 
Johnson Controls, Inc.

1 Memory buttons
2 LED

1.

Switch on the ignition.

2.

When using for the first time: press both 
outer buttons

1 for approx. 20 seconds, 

maintaining pressure until the LED

2 starts 

to flash. The three memory buttons

1 are 

cleared.

3.

Hold the original hand-held transmitter at a 
distance  of  approx.  2 in/5 cm  to  8 in/20 cm 
from the memory buttons

1.

The required distance between the 
hand-held transmitter and memory 

buttons

1 depends on the relevant system 

of the original hand-held transmitter used.

<

4.

Simultaneously press the transmit button 
on the original hand-held transmitter and 
the desired memory button

1 of the inte-

grated universal remote control. The LED

2 

flashes slowly at first. As soon as the LED

2 

flashes rapidly, release both buttons. If the 
LED

2 does not flash rapidly after approx. 

15 seconds, alter the distance.

5.

To program other original hand-held trans-
mitters, repeat steps 3 and 4.

The corresponding memory button

1 is now 

programmed with the signal of the original 
hand-held transmitter.
You can operate the system when the engine is 
running or when the ignition is switched on.

Online Edition for Part No. 01 41 0 012 254 - © 02/06 BMW AG