BMW 2006 760Li Sedan Manual Do Proprietário

112

If the device cannot be operated after 
repeated programming, check whether 

the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the 
instructions of the original hand-held transmit-
ter or press and hold down the programmed 
memory button

1 of the integrated universal 

remote control. If the LED

2 on the integrated 

universal remote control flashes rapidly for a 
short time and then remains lit for approx. 
2 seconds, then this indicates that the original 
hand-held transmitter is equipped with an alter-
nating-code system. In the case of an alternat-
ing-code system, program the memory but-
tons

1 as described in the Alternating-code 

transmitters section below.

<

Consult the operating instructions of the unit 
you wish to set when programming the univer-
sal remote control. You will find information 
there on the possibilities for synchronization.
When programming hand-held transmitters 
that employ an alternating code, please follow 
the supplementary instructions below:

Programming will be easier with the aid of 
a second person.

<

1.

Park your vehicle within the range of the 
remote-controlled device.

2.

Program the integrated universal remote 
control as described above in the Fixed-
code hand-held transmitters section.

3.

Locate the button on the receiver of the 
device you want to set up, e.g. on the upper 
section of its motor.

4.

Press the button on the receiver of the 
device you want to set up. After step 4, you 
have approx. 30 seconds for step 5.

5.

Press the programmable memory button

1 

on the integrated universal remote control 
three times.

The corresponding memory button

1 is now 

programmed with the signal of the original 
hand-held transmitter.

If you have any additional questions, 
please contact your BMW center.

<

Press both outer buttons

1 for approx. 20 sec-

onds, maintaining pressure until the LED

2 

starts to flash: 
All of the memory buttons have been cleared.
It is not possible to clear individual memory 
buttons

1.

Briefly press the button on the driver's door with 
the ignition in radio ready state or higher.

1 Quarter window blind
2 Side window blind
3 Rear window blind
4 Switching to the other side
Briefly press the corresponding button with the 
ignition in radio ready state or higher.

The side window blind can not be 
extended unless the side window is 

closed. If the window is open, the blind will rise 
slightly prior to immediately retracting to its 
original position.

<

Online Edition for Part No. 01 41 0 012 254 - © 02/06 BMW AG