BMW 2006 530i Sedan Manual Do Proprietário

Página de 259
 85
Technology for comfort, convenience and 
safety
PDC Park Distance Control*
The concept
The PDC assists you when you are parking. 
Acoustic signals and an optical display
*
 alert 
you to the approach of an object from behind 
your vehicle. To measure the distance, there 
are four ultrasonic sensors in each bumper. 
The range of these sensors is approx. 7 ft/2 m. 
However, an acoustic warning first sound for 
the sensors at the front and at the two rear cor-
ners at approx. 24 in/60 cm, and for the center 
rear sensors at approx. 5 ft/1.50 m.
PDC is a parking aid that can indicate 
objects when they are approached 
slowly, as is usually the case when parking. 
Avoid approaching an object at high speed, oth-
erwise the physical circumstances would mean 
that the system warning was too late.
<
Automatic activation
The system starts to operate automatically 
approx. 1 second after you select reverse gear 
or move the selector lever into the R position 
with the engine running or the ignition switched 
on.
Wait this short period before driving.
Manual activation
Press button, the LED lights up.
Manual deactivation
Press the button again; the LED goes out.
After driving approx. 165 ft/50 m or at over 
approx. 20 mph/30 km/h, the system is 
switched off and the LED goes out. You can 
reactivate the system manually as needed.
Signal tones
When nearing an object, the position is corre-
spondingly indicated by an interval tone. Thus, 
an object detected to the left rear of the vehicle 
will be indicated by a signal tone from the left 
rear speaker, etc. As the distance between 
vehicle and object decreases, the intervals 
between the tones become shorter. If the dis-
tance to the nearest object falls to below 
roughly 1 ft/30 cm, then a continuous tone 
sounds.
An intermittent tone is interrupted after approx. 
3 seconds:
>
if you remain in front of an object that was 
only detected by one of the corner sensors
>
if you drive parallel to a wall
Malfunction
The LED in the button flashes and a message 
appears on the Control Display. PDC is mal-
functioning. Have the system checked.
To prevent this problem, keep the sensors 
clean and free of ice or snow in order to ensure 
that they will continue to operate effectively. Do 
not spray the sensors with high-pressure clean-
ers for long periods and maintain a distance of 
at least 4 in/10 cm to them.
PDC with visual warning*
You can also have the system show distances 
to objects on the Control Display. Objects that 
are farther away are already shown there before 
a signal tone sounds. The setting is stored for 
the remote control currently in use.
Online Edition for Part No. 01 41 0 012 211 - © 02/06 BMW AG