BMW 2005 645Ci Convertible Manual Do Proprietário

100

The integrated universal remote control 
replaces up to three different hand-held trans-
mitters for various items of radio-controlled 
equipment such as door openers and house 
alarm systems. The integrated universal remote 
control registers and stores signals from the 
original hand-held transmitters.
The signal of an original hand-held transmitter 
can be programmed into one of the three mem-
ory buttons

1. Then the respective device can 

be actuated using the memory button

1 pro-

grammed for its use when the ignition key is in 
position 2. The LED

2 flashes to confirm trans-

mission of the signal.
If you sell your vehicle one day, delete the saved 
programs beforehand for your own security, 
refer to page

.

To prevent possible damage or injury, 
before programming or using the inte-

grated universal remote control, always inspect 
the immediate area to make certain that no peo-
ple, animals or objects are within the travel 
range of the device. Also comply with the safety 
precautions of the original hand-held transmit-
ter.

<

If you see this symbol on the packaging 
or in the manual supplied with the orig-
inal hand-held transmitter, it is safe to 

assume that it is compatible with the integrated 
universal remote control.
If you have additional questions, please consult 
your BMW center or call 1-800-355-3515.
You can also visit these websites:
www.bmwusa.com or 
www.homelink.com. 
HomeLink is a registered trademark owned by 
Johnson Controls, Inc.

1 Memory buttons
2 LED

1.

Ignition key in position 2.

2.

When using for the first time: press both 
outer buttons 

1 for approx. 20 seconds, 

maintaining pressure until the LED 

2 starts 

to flash. The three memory buttons

1 are 

cleared.

3.

Hold the original hand-held transmitter at a 
distance of approx. 2 in/5 cm to 8 in/20 cm 
to the memory buttons

1.

The required distance between the 
hand-held transmitter and the mem-

ory buttons

1 depends on the respective 

system of the original hand-held transmitter 
used.

<

4.

Simultaneously press the transmit button 
on the original hand-held transmitter and 
the desired memory button

1 on the inte-

grated universal remote control. Initially, the 
LED

2 flashes slowly. Release both buttons 

as soon as the LED 

2 flashes rapidly. If the 

LED

2 does not flash rapidly after approx. 

15 seconds, change the distance.

5.

To program other original hand-held trans-
mitters, repeat steps 3 and 4.

The corresponding memory button

1 is now 

programmed with the signal of the original 
hand-held transmitter.

Online Edition for Part-No. 01 41 0 158 445 - © 09/04 BMW AG