BMW 2005 645Ci Convertible Manual Do Proprietário

 101

You can operate the system when the ignition 
key is in position 2.

If the device cannot be used after 
repeated programming, check whether 

the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the 
instructions for the original hand-held transmit-
ter or press the programmed memory button

1 

of the integrated universal remote control 
longer. If the LED 

2 on the integrated universal 

remote control flashes rapidly for a short time 
then lights up for approx. 2 seconds, this indi-
cates that the original hand-held transmitter 
uses an alternating-code system. In the case of 
an alternating-code system, program the mem-
ory buttons

1 as described at Alternating-code 

hand-held transmitters.

<

To program the integrated universal remote 
control, consult the operating instructions for 
the equipment to be set. You will find informa-
tion there on the possibilities for synchroniza-
tion.
When programming hand-held transmitters 
that employ an alternating code, please observe 
the following supplementary instructions:

Programming will be easier with the aid of 
a second person.

<

1.

Park your vehicle within the range of the 
remote-controlled equipment.

2.

Program the integrated universal remote 
control as described above at Fixed-code 
hand-held transmitters.

3.

Locate the button at the receiver of the 
equipment to be set, e.g. on the drive.

4.

Press the button on the receiver of the 
equipment to be set. After step 4, you have 
approx. 30 seconds for step 5.

5.

Press the programmed memory button

1 of 

the integrated universal remote control 
three times.

The corresponding memory button

1 is now 

programmed with the signal of the original 
hand-held transmitter.

Press both outer buttons 

1 for approx. 20 sec-

onds, maintaining pressure until the LED 

2 

starts to flash: All of the memory buttons are 
cleared.
The memory of individual memory buttons

1 

cannot be cleared.

Press the button. The glove compartment 
opens automatically and the lamps come on.

Fold the cover up.

To prevent injury in the event of an acci-
dent while the vehicle is being driven, 

close the glove compartment immediately after 
use.

<

The flashlight is located on the left side of the 
glove compartment.
The flashlight can remain there continuously.

Be sure that the flashlight is switched off 
when it is inserted into its holder. Failure 

to comply with this precaution could lead to 
overcharging and damage.

<

Online Edition for Part-No. 01 41 0 158 445 - © 09/04 BMW AG