BMW 2004 645Ci Convertible Manual Do Proprietário

94

The integrated universal remote control 
replaces up to three different hand-held 
transmitters for various items of radio-con-
trolled equipment such as door openers 
and house alarm systems. The integrated 
universal remote control registers and 
stores signals from the original hand-held 
transmitters.

The signal of an original hand-held trans-
mitter can be programmed on one of the 
three memory buttons 1. Then the respec-
tive device can be actuated with the mem-
ory button 1 programmed for its use with 
the ignition key in position 2. The indicator 
lamp 2 flashes to confirm transmission of 
the signal.

If you sell your vehicle one day, delete the 
saved programs beforehand for your own 
security, refer to page 

To prevent possible damage or injury, 
before programming or using the inte-

grated universal remote control, always 
inspect the immediate area to make certain 
that no people, animals or objects are 
within the travel range of the device. Also, 
comply with the safety precautions of the 
original hand-held transmitter.

<

If you see this symbol on the pack-
aging or in the manual supplied with 
the original hand-held transmitter, it 

is safe to assume that it is compatible with 
the integrated universal remote control.

If you have additional questions, please 
consult your BMW Sports Activity Vehicle 
Center or call 1-800-355-3515.
You can also visit these websites:
www.bmwusa.com or 
www.homelink.com. 

HomeLink is a registered trademark owned 
by Johnson Controls, Inc.

Memory buttons

Indicator lamp

1.

Ignition key in position 2

2.

When using for the first time: press both 
outer buttons 1 for approx. 20 seconds, 
maintaining pressure until the indicator 
lamp 2 starts to flash. The three mem-
ory buttons 1 are cleared

3.

Hold the original hand-held transmitter 
at a distance of approx. 2 in/5 cm to 
8 in/20 cm to the memory buttons 1

The required distance between 
the hand-held transmitter and the 

memory buttons 1 depends on the rele-
vant system of the original hand-held 
transmitter used.

<

4.

Simultaneously press the transmit but-
ton on the original hand-held transmit-
ter and the desired memory button  1 on 
the integrated universal remote control. 
Initially, the indicator lamp 2 flashes 
slowly. Release both buttons as soon 
as the indicator lamp 2 flashes rapidly. 
If the indicator lamp 2 does not flash 
rapidly after approx. 15 seconds, 
change the distance

5.

To program other original hand-held 
transmitters, repeat steps 3 and 4.

Online Edition for Part No. 01 41 0 157 980 - © 01/04 BMW AG