BMW 2004 645Ci Convertible Manual Do Proprietário

 95

The corresponding memory button 1 is 
now programmed with the signal of the 
original hand-held transmitter.

The equipment can be used in ignition key 
position 2.

If the device cannot be operated after 
repeated programming, check 

whether the original hand-held transmitter 
uses an alternating-code system. Here, 
either read the instructions for the original 
hand-held transmitter or hold down the 
programmed memory button 1 of the inte-
grated universal remote control. If the indi-
cator lamp 2 on the integrated universal 
remote control flashes rapidly for a short 
time then lights up for approx. 2 seconds, 
this indicates that the original hand-held 
transmitter uses an alternating-code sys-
tem. In the case of an alternating-code sys-
tem, program the memory buttons 1 as 
described at Alternating-code hand-held 
transmitters.

<

To program the integrated universal remote 
control, consult the Operating Instructions 
for the equipment to be set. You will find 
information there on the possibilities for 
synchronization.
When programming hand-held transmitters 
that employ an alternating code, please 
observe the following supplementary 
instructions:

Programming will be easier with the 
aid of a second person.

<

1.

Park your vehicle within the range of the 
remote-controlled equipment

2.

Program the integrated universal 
remote control as described above at 
Fixed-code hand-held transmitters

3.

Locate the button at the receiver of the 
equipment to be set, e.g. on the drive

4.

Press the button on the receiver of the 
equipment to be set. After step 4, you 
have approx. 30 seconds for step 5

5.

Press the programmed memory 
button 1 of the integrated universal 
remote control three times.

The corresponding memory button 1 is 
now programmed with the signal of the 
original hand-held transmitter.

If you have any additional questions, 
please contact your BMW center.

<

Press both outer buttons 1 of the inte-
grated universal remote control for approx. 
20 seconds, maintaining pressure until the 
indicator lamp 2 starts to flash. All three 
memory buttons are cleared.

The memory of individual memory but-
tons 1 cannot be cleared.

Press button. The glove compartment 
opens automatically and the lamps come 
on.

Fold the cover up.

To prevent injury in the event of an 
accident while the vehicle is being 

driven, close the glove compartment 
immediately after use.

<

The flashlight is located on the left side of 
the glove compartment.
The flashlight can remain there continu-
ously.

Online Edition for Part No. 01 41 0 157 980 - © 01/04 BMW AG