BMW 745LI Manual Do Utilizador

72

Standard wiper speed: briefly press 
once. 
Fast wipe: briefly press twice 

To switch off wipers or for brief wipe 

To activate/deactivate rain sensor 

To clean windshield and headlamps 

To adjust rain sensor sensitivity level

The lever automatically returns to its 
initial position when released.

<

 

The system automatically reverts to opera-
tion in the intermittent mode whenever the 
vehicle stops. 

You can also select this position by 
pressing the lever upward past the detent. 

The system automatically reverts to opera-
tion in the standard wiper speed whenever 
the vehicle stops. 

The system sprays washer fluid against the 
windshield and activates the wipers for a 
brief period. 

Each fifth time you press into position 4 to 
clean the windshield while the headlamps 
are on. 

Do not use the washers if there is any 
danger that the fluid will freeze on the 

windshield. If you do so, your vision could 
be obscured. To avoid freezing, use a 

washer fluid antifreeze, refer to page 

Avoid activating the washer when the 
reservoir is empty, as damage to the pump 
could result.

<

 

The windshield washer nozzles and the 
windshield itself in the area around the 
wipers are heated automatically when the 
ignition is switched on. 

The rain sensor is located on the wind-
shield, directly in front of the interior rear-
view mirror. 

Press briefly with ignition in radio mode. 
The indicator lamp comes on. The wipers 
will always respond by completing at least 
one sweep of the windshield. 

Turn the rotary knob 5. 

Press the button again. The indicator lamp 
goes out. 

The rain sensor is automatically deac-
tivated when you switch off the igni-

tion.

<

 

Deactivate the rain sensor when 
passing through an automatic car 

wash. Failure to do so could result in 
damage caused by undesired wiper activa-
tion.

<

 

Online Edition for Part No. 01 41 0 157 197 - © 11/02 BMW AG