BMW 745i Manual Do Proprietário

114

The integrated universal remote control 
can replace as many as three hand-held 
transmitters for various remote-controlled 
accessories, such as door openers and 
house alarm systems. The integrated uni-
versal remote control registers and stores 
signals from the original hand-held trans-
mitters. 

The signal of an original hand-held trans-
mitter can be programmed on one of the 
three memory keys 1. Following that, each 
of the devices can be actuated with the 
appropriately-programmed memory key 1. 
The indicator lamp 2 flashes to confirm 
transmission of the signal. 

If the vehicle is sold, the memory keys 1 
should be cleared as described on 
page 

. 

To prevent possible damage or injury, 
before programming or using the inte-

grated universal remote control, always 
inspect the immediate area to make certain 
that no people, animals or objects are 
within the travel range of the device. Also, 
comply with the safety precautions of the 
original hand-held transmitter.

<

 

If you see this symbol on the pack-
aging or in the manual supplied with 
the original hand-held transmitter, it 

is safe to assume that it is compatible with 
the integrated universal remote control. 

If you have additional questions, 
please consult your BMW center or 

call 1-800-355-3515.
You can also visit these websites:
www.bmwusa.com or 
www.homelink.com. 
HomeLink is a registered trademark owned 
by Johnson Controls, Inc.

<

 

Memory keys

Indicator lamp  

1.

Switch on the ignition

2.

When using for the first time: press both 
outer keys 1 for approx. 20 seconds, 
maintaining pressure until the indicator 
lamp 2 starts to flash. The three 
memory keys 1 are cleared

3.

Hold the original hand-held transmitter 
at a distance of approx. 2 in (5 cm) to 
8 in (20 cm) from the memory keys 1.

The required distance between 
the hand-held transmitter and 

memory keys 1 depends on the rele-
vant system of the original hand-held 
transmitter used.

<

4.

Simultaneously press the transmit key 
on the original hand-held transmitter 
and the desired memory key 1 of the 
integrated universal remote control. 
First, the indicator lamp 2 flashes 
slowly. Release both keys 2 as soon as 
the indicator lamp flashes rapidly. If the 
indicator lamp 2 does not flash quickly 
after approx. 15 seconds, choose 
another distance

5.

To program other original hand-held 
transmitters, repeat steps 3 and 4. 

The corresponding memory key 1 is now 
programmed with the signal of the original 
hand-held transmitter. 

Online Edition for Part No. 01 41 0 157 197 - © 11/02 BMW AG