BMW 2004 760i Sedan Manual Do Proprietário

Página de 232
 201
1
High beams 
Press the tab down, refer to arrow.
Always wear gloves and eye protec-
tion – the atmosphere within the bulb 
is pressurized. Failure to observe this pre-
caution can lead to personal injury should 
the bulb be damaged.
<
 
1 High beams 
H7 bulb, 55 watts
1.
Remove the cover 
2.
Turn the bulb holder to the left and 
remove 
3.
Remove and replace the bulb. 
Xenon lamps
The service life of these bulbs is very long 
and the probability of a failure is very low, 
provided that they are not switched on and 
off an unusual number of times.
In the unlikely event that one of these 
lamps should fail, you can respond by 
switching on your fog lamps and proceed-
ing carefully, where allowed by law. 
To avoid risk of potentially fatal inju-
ries: owing to the extremely high volt-
ages at which these units operate, service 
work should always be entrusted to quali-
fied personnel.
<
 
Parking and standing lamps 
In the event of a malfunction, please con-
tact your BMW center. 
Turn signal indicator, front 
Two bulbs – 3457AK or 3457NAK
*
 
1.
Turn the bulb holder to the left and 
remove 
2.
Apply gentle pressure to the bulb while 
turning it to the left for removal and 
replacement. 
Side-mounted turn signal indicators 
Bulb 5 watts – W 5 W 
1.
Press against the front edge of the lamp 
with the tip of your finger, then push it to 
the rear and release the detent at the 
front 
2.
Turn the lamp 90 3 and remove 
3.
Turn the bulb holder to the left and 
remove 
4.
Extract the bulb for replacement. 
Online Edition for Part No. 01 41 0 157 670 - © 08/03 BMW AG