BMW 2004 760i Sedan Manual Do Proprietário

Página de 232
 203
Change the wheel only on a level, firm sur-
face which is not slippery. The vehicle or 
the jack could slip to the side if you attempt 
to raise the vehicle on a soft or slippery sur-
face such as snow, ice, tiles, etc.  
Position the jack on a firm support surface.
Do not use a wooden block or similar 
object as a support base for the jack, as 
this would prevent it from extending to its 
full support height and reduce its load-car-
rying capacity.
To avoid serious or fatal injury: never lie 
under the vehicle, and never start the 
engine while it is supported by the jack.
<
 
What you will need 
To avoid rattling noises, note the positions 
of the tools before removing them, then 
return them to their initial positions after 
completing work. 
>
Lug wrench 
Located beside the spare tire 
>
Wheel chock 
The chock is located next to the spare 
tire, or behind the trim panel on the left 
side of the luggage compartment on 
vehicles equipped with a trailer cou-
pling. 
Remove the floor mat and the cover 
above the spare tire. 
Unscrew the wingnut and remove the 
wheel chock 
>
Jack 
The jack is located behind the side trim 
panel on the right side of the luggage 
compartment. 
Grasp the handle in the upper panel 
and fold it down. 
Unscrew the wingnut and remove the 
jack. 
After use, screw the jack all the way 
back down and snap the handle back 
into place. 
Spare tire 
1.
Unscrew wing nut 1 
2.
Remove disk 2 to the side 
3.
Completely unscrew threaded rod 3 
4.
Remove the wheel. 
Procedure 
1.
Read carefully and comply with the 
safety precautions on page 
 
2.
Secure the vehicle to prevent it from 
rolling: 
Place the wheel chock against the rear 
Online Edition for Part No. 01 41 0 157 670 - © 08/03 BMW AG