BMW 2004 525i Sedan Manual Do Proprietário

Practical interior accessories

Integrated universal remote
control*

The concept

The integrated universal remote control
replaces up to three different hand-held
transmitters for various remote-controlled
equipment such as door openers and
house alarm systems. The integrated uni-
versal remote control registers and stores
signals from the original hand-held trans-
mitters.

The signal of an original hand-held trans-
mitter can be programmed on one of the
three memory buttons 1. Following that,
each of the devices can be actuated with
the appropriately programmed memory
button 1. The indicator lamp 2 flashes to
confirm transmission of the signal.

If the vehicle is sold, the memory of the but-
tons 1 should be cleared, refer to page

To prevent possible damage or injury,
before programming or using the inte-

grated universal remote control, always
inspect the immediate area to make certain
that no people, animals or objects are
within the travel range of the device. Also,
comply with the safety precautions of the
original hand-held transmitter.

Checking the compatibility

If you see this symbol on the pack-
aging or in the manual supplied with
the original hand-held transmitter, it

is safe to assume that it is compatible with
the integrated universal remote control.

If you have additional questions,
please consult your BMW center or

call 1-800-355-3515.
You can also visit these websites:
www.bmwusa.com or
www.homelink.com.
HomeLink is a registered trademark owned
by Johnson Controls, Inc.

Programming

Memory buttons

Indicator lamp

Fixed-code hand-held transmitter

Turn the ignition key to position 2

When using for the first time:
Press both outer buttons 1 for approx.
20 seconds until the indicator lamp 2
flashes. The three memory buttons 1
are cleared

Hold the original hand-held transmitter
at a distance of approx. 2 in/5 cm to
8 in/20 cm to the memory buttons 1

The required distance between
the hand-held transmitter and the

memory buttons 1 depends on the rele-
vant system of the original hand-held
transmitter used.

Simultaneously press the transmit but-
ton on the original hand-held transmit-
ter and the desired memory button 1 on
the integrated universal remote control.
Initially, the indicator lamp 2 flashes
slowly. Release both buttons as soon
as the indicator 2 lamp flashes rapidly. If
the indicator lamp 2 does not flash rap-
idly after approx. 15 seconds, change
the distance

To program other original hand-held
transmitters, repeat steps 3 and 4.

The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.