BMW 2004 525i Sedan Manual Do Proprietário

 97

The equipment can be used as of ignition 
key position 2.

If the device cannot be used even 
after repeated programming, check 

whether the original hand-held transmitter 
is equipped with an alternating-code sys-
tem. Here, either read the instructions for 
the original hand-held transmitter or hold 
down the programmed memory button  1 of 
the integrated universal remote control. If 
the indicator lamp 2 on the integrated uni-
versal remote control flashes rapidly for a 
short time then lights up for approx. 2 sec-
onds, this indicates that the original hand-
held transmitter uses an alternating-code 
system. In the case of an alternating-code 
system, program the memory buttons 1 as 
described at Alternating-code hand-held 
transmitters.

<

To program the integrated universal remote 
control, consult the operating instructions 
for the equipment to be set. You will find 
information there on the possibilities for 
synchronization.
When programming hand-held transmitters 
that employ an alternating code, please 
observe the following supplementary 
instructions: 

Programming will be easier with the 
aid of a second person.

<

1.

Park your vehicle within the range of the 
remote-controlled device 

2.

Program the integrated universal 
remote control as described above at 
Fixed-code hand-held transmitters 

3.

Locate the button at the receiver of the 
equipment to be set, e.g. on the drive 

4.

Press the button on the receiver of the 
device you want to set up. After step 4, 
you have approx. 30 seconds for step 5

5.

Press the programmed memory 
button 1 of the integrated universal 
remote control three times. 

The corresponding memory button 1 is now 
programmed with the signal of the original 
hand-held transmitter. 

If you have any additional questions, 
please contact your BMW center.

<

Press both outer buttons 1 of the inte-
grated universal remote control for approx. 
20 seconds until the indicator lamp 2 
flashes. All memory buttons will be cleared. 

The memory of individual memory 
buttons 1 cannot be cleared. 

To actuate as of ignition key position 1, 
briefly press the button in the driver's door. 

Pull the roller sun blind at the loop and 
hook up to the bracket. 

Online Edition for Part No. 01 41 0 157 647 - © 07/03 BMW AG