BMW 2004 745i Sedan Manual Do Proprietário

 111

The integrated universal remote control 
can replace as many as three hand-held 
transmitters for various remote-controlled 
accessories, such as door openers and 
house alarm systems. The integrated uni-
versal remote control registers and stores 
signals from the original hand-held trans-
mitters.

The signal of an original hand-held trans-
mitter can be programmed on one of the 
three memory buttons 1. Following that, 
each of the devices can be actuated with 
the appropriately-programmed memory 
button 1. The indicator lamp 2 flashes to 
confirm transmission of the signal.

If the vehicle is sold, the memory buttons  1 
should be cleared as described on 
page 

To prevent possible damage or injury, 
before programming or using the inte-

grated universal remote control, always 
inspect the immediate area to make certain 
that no people, animals or objects are 
within the travel range of the device. Also, 
comply with the safety precautions of the 
original hand-held transmitter.

<

 

If you see this symbol on the pack-
aging or in the manual supplied with 
the original hand-held transmitter, it 

is safe to assume that it is compatible with 
the integrated universal remote control.

If you have additional questions, 
please consult your BMW center or 

call 1-800-355-3515.
You can also visit these websites:
www.bmwusa.com or 
www.homelink.com. 
HomeLink is a registered trademark owned 
by Johnson Controls, Inc.

<

 

Memory buttons

Indicator lamp 

1.

Switch on the ignition

2.

When using for the first time: press both 
outer buttons  1 for approx. 20 seconds, 
maintaining pressure until the indicator 
lamp 2 starts to flash. The three mem-
ory buttons 1 are cleared

3.

Hold the original hand-held transmitter 
at a distance of approx. 2 in/5 cm to 
8 in/20 cm from the memory buttons 1

The required distance between 
the hand-held transmitter and 

memory buttons 1 depends on the rele-
vant system of the original hand-held 
transmitter used.

<

4.

Simultaneously press the transmit but-
ton on the original hand-held transmit-
ter and the desired memory button 1 of 
the integrated universal remote control. 
Initially, the indicator lamp 2 flashes 
slowly. Release both buttons as soon 
as the indicator lamp 2 flashes rapidly. If 
the indicator lamp 2 does not flash rap-
idly after approx. 15 seconds, change 
the distance

5.

To program other original hand-held 
transmitters, repeat steps 3 and 4. 

The corresponding memory button 1 is 
now programmed with the signal of the 
original hand-held transmitter.

Online Edition for Part No. 01 41 0 157 670 - © 08/03 BMW AG