BMW 2004 745i Sedan Manual Do Proprietário

112

The device can be operated as of ignition 
on.

If the device cannot be operated 
after repeated programming, check 

whether the original hand-held transmitter 
uses an alternating-code system. To do so, 
either read the instructions of the original 
hand-held transmitter or press and hold 
down the programmed memory button  1 of 
the integrated universal remote control. 
If the indicator lamp 2 on the integrated 
universal remote control flashes quickly for 
a brief period and then remains lit up for 
approx. two seconds, this indicates that 
the original hand-held transmitter is 
equipped with an alternating-code sytem. 
In the case of an alternating-code system, 
program the memory buttons 1 as 
described at the section on alternating-
code transmitters.

<

Consult the operating instructions of the 
unit you wish to set when programming the 
integrated universal remote control. You 
will find information there on the possibili-
ties for synchronization.
When programming hand-held transmitters 
that employ an alternating code, please 
observe the following supplementary 
instructions:

Programming will be easier with the 
aid of a second person.

<

1.

Park your vehicle within the range of the 
remote-controlled device

2.

Program the integrated universal 
remote control as described at the sec-
tion on fixed-code hand-held transmit-
ters

3.

Localize the button on the receiver of 
the device you want to set up, e.g. on 
the upper section of the motor

4.

Press the button on the receiver of the 
device you want to set up. After step 4, 
you have approx. 30 seconds for step 5

5.

Press the programmed memory 
button 1 on the integrated universal 
remote control three times. 

The corresponding memory button 1 is 
now programmed with the signal of the 
original hand-held transmitter. 

If you have any additional questions, 
please contact your BMW center.

<

 

Individual memory buttons 1 can not be 
cleared. However, you clear all three mem-
ory buttons 1 together as follows:

Press both outer buttons 1 of the inte-
grated universal remote control for approx. 
20 seconds, maintaining pressure until the 
indicator lamp 2 starts to flash.

To actuate from the radio position, briefly 
press the button in the driver's door. 

Activate by briefly pressing the desired but-
ton with the ignition lock in the radio mode.

Quarter window blind 

Side window blind 

Online Edition for Part No. 01 41 0 157 670 - © 08/03 BMW AG