Bosch Appliances Home Security System 3.5 Manual Do Utilizador
Bosch Security Systems | 2011-02
Praesideo 3.5 | Installation and User Instructions | 6 | Installation Accessories
en | 274
26.3.5Operation
The two LEDs on the fiber interface provide
information about the status of the fiber interface.
information about the status of the fiber interface.
26.4 Installation
The fiber interface can be attached to a wall or any
other flat surface using a bracket (see figure 26.10). The
distance between the holes in the bracket is 40 mm.
other flat surface using a bracket (see figure 26.10). The
distance between the holes in the bracket is 40 mm.
Mounting of this bracket and the unit on a drywall sheet
construction requires screws with a minimum screw
length of 22 mm (7/8") and a minimum diameter of
2.5 mm (3/32"). Mounting was evaluated for use on a
drywall surface only.
construction requires screws with a minimum screw
length of 22 mm (7/8") and a minimum diameter of
2.5 mm (3/32"). Mounting was evaluated for use on a
drywall surface only.
table 26.5: Status LED indications
Yellow
Yellow
(Fault)
Green
(Power)
Status
Off
Off
Off; no external power
available.
On
Off
Stand-by; external power to
POF switched off.
On
On
Operating; external power to
POF switched on.
Off
On
Operating; no external power
available, but powered from the
POF side.
Off
Blink
Fault, no external power
available and no protocol
received.
On
Blink
Fault, external power available,
but no protocol received.
Note
The PRS-FINNA cannot detect if the correct
The PRS-FINNA cannot detect if the correct
protocol is received. Therefore, its green LED
does not show the fault status of table 26.5.
figure 26.10: Installation
6
d