Behringer FCB1010 Manual Do Proprietário

MIDI FOOT CONTROLLER FCB1010 User Manual

2.1.1  DIRECT SELECT deactivated
Let’s assume you wish to select PRESET #1 from BANK #3...

Step 1
Use the UP/DOWN switches to go to the BANK that contains the PRESET of your 

choice (here: BANK #3).

Step 2
Select the PRESET you wish to use (here: PRESET #1).

Step 2

Step 1

Fig. 2.1: PRESET selection with DIRECT SELECT disabled

2.1.2  DIRECT SELECT activated
If DIRECT SELECT is on, do as follows to select PRESET #1 from BANK #3 

(activating DIRECT SELECT is discussed in ch. 2.2.1):

Step 1
Select the BANK of your choice (here: BANK #3) by stepping on footswitch #3.

Step 2
Select the PRESET you wish to use (here: PRESET #1) by stepping on footswitch 

#1. The display shows that preset 31 is selected. 

Step 2

Step 1

Fig. 2.2: PRESET selection with DIRECT SELECT enabled

As this example shows, the DIRECT SELECT feature gives you a faster access to 

BANKS and PRESETS than without this function. Which option to use is entirely up 

to you. As long as you need the PRESETS from one BANK only, it will be advisable 

to disable the DIRECT SELECT function because this way you can recall a new 

preset with only one keystroke.

In the GLOBAL CONFIGURATION menu you can set the parameters that apply to 

both the PRESETS and FUNCTIONS of your FCB1010 (e.g. MIDI channel selection, 

SysEx SEND & RCV, DIRECT SELECT etc.). Keep the DOWN switch pressed during 

power-up for about 2.5 sec to enter GLOBAL CONFIGURATION mode. 
The DIRECT SELECT LED in the display lights up.
You can use the UP and DOWN keys to navigate through GLOBAL CONFIGURATION 

main pages. Pressing UP leafs through the pages forward, pressing DOWN leafs 

the pages backward. A corresponding LED indicates what page you are on.

CONFIG.

SELECT

MIDI CHANNEL

SELECT

MIDI FUNCTION

GLOBAL

CONFIGURATION

DIRECT SELECT

DOWN

UP

DOWN

DOWN

UP

Fig. 2.3: GLOBAL CONFIGURATION menu structure 

To leave GLOBAL CONFIGURATION menu, you need to press the DOWN/ESCAPE key 

for at least 2.5 sec.

2.2.1  DIRECT SELECT page
Keep the DOWN/ESCAPE key pressed while you power up the unit. This takes you 

to the GLOBAL CONFIGURATION menu; the green DIRECT SELECT LED lights up. 

To activate DIRECT SELECT, press 10/0 key. The red LED lights up. Now, you have 

to confirm activating DIRECT SELECT to be able to directly select presets. To do 

this, keep DOWN/ESCAPE pressed for 2.5 sec. to exit GLOBAL CONFIGURATION. 

The display now shows “00”. Now you can directly select the presets, as described 

in ch. 2.1.2.