Yamaha DVD-C961 Manual Do Proprietário

You can set the digital output and LPCM 
output.

• Select [DIGITAL AUDIO] in “AUDIO 

SETUP PAGE”.

Set the digital output according to your 
optional audio component connections.

Select this to turn off the digital output.

Select this if you have connected the digital 
audio output jack to a multi-channel decoder/
receiver. 
Dolby Digital, DTS, MPEG-2 and PCM digital 
audio signals are output.
Also refer to the manual supplied with the 
connected component.

Select this only if your receiver is not capable 
of decoding multi-channel audio signals. 
Multi-channel audio signals are converted to 
2-channel linear PCM audio signals.

Select this if you have connected this unit to a 
PCM-compatible receiver via a digital jack, 
such as a coaxial jack. In this case, you may 
need to adjust [LPCM OUT].
Discs are recorded at a certain sampling rate. 
The higher the sampling rate, the better the 
sound quality.

Select this to play back discs recorded at the 
sampling rate of 48 kHz. All higher than 48 
kHz PCM data streams (if available) are 
converted to the sampling rate of 48 kHz or 
lower.

Select this to play back discs recorded at the 
sampling rate of 96 kHz. If higher than 48 kHz 
disc is copy protected, the digital output is 
automatically converted to the sampling rate of 
48 kHz or lower.

• When HDMI audio signals are output, you cannot 

select [DIGITAL AUDIO].

• When Dolby Pro Logic II decoder is activated, 

the sampling rate of digital output is limited to 48 
kHz or lower.

When you connect this unit to an HDMI 
compatible component via the HDMI jack, set 
the HDMI audio output to match the 
connected component. For details about the 
relationship between the audio format and the 
setting, see “HDMI audio output” on page 13.

• Select [HDMI AUDIO OUT] in “AUDIO 

SETUP PAGE”.

Select this to set this unit to the best setting 
automatically based on the component you 
have connected via the HDMI jack.

Select this to output the decoded multi-
channel or 2-channel PCM audio signals via 
the HDMI jack. To select multi-channel or 2-
channel output, set [ANALOG OUTPUT] (see 
page 31).

Select this to turn off the HDMI audio output.

• If the monitor/receiver connected to this unit 

using HDMI does not support HDMI audio signal 
input, set this setting to [OFF].

• When [HDMI AUDIO OUT] is set to [AUTO] or 

[PCM], digital output signals are muted.

This function is used to enable or disable the 
speaker settings.

• Select [SPEAKER SETUP] in “AUDIO 

SETUP PAGE”.

Select this to enable to set [SPEAKERS] (see 
pages 33).