ONKYO CHAD Manual Do Proprietário
19
ChadEdit User Guide
•
USR-5 not connected or not responding. You can click on the
Details >> button to open a window listing all the serial ports on
your PC.
Details >> button to open a window listing all the serial ports on
your PC.
•
If another application is using the serial port to which your USR-
5 is connected you can either try another serial port or have the
other application release the serial port.
5 is connected you can either try another serial port or have the
other application release the serial port.
•
If ChadEdit could open the serial port to which your USR-5 is
connected but still could not connect, check to see if both ends of
the cable are properly inserted and if USR-5’s batteries have not
run out. Then wait a few seconds and try again. If after a number
of tries ChadEdit still cannot connect, try resetting your USR-5,
wait until it beeps twice and try again.
connected but still could not connect, check to see if both ends of
the cable are properly inserted and if USR-5’s batteries have not
run out. Then wait a few seconds and try again. If after a number
of tries ChadEdit still cannot connect, try resetting your USR-5,
wait until it beeps twice and try again.
See How do I create a macro? for information on how to assign more than a single IR code to a button.
How do I assign an IR code to a direct-access or left/right key?
The USR-5 has two kinds of key definitions: global and per-device. Whenever there is no per-device definition
(or an empty per-device definition), the global definition is used. There is only one global definition per key, but
there is a per-device definition per key for every device and macro group.
(or an empty per-device definition), the global definition is used. There is only one global definition per key, but
there is a per-device definition per key for every device and macro group.
•
to assign an IR code to the global definition of a key:
1. Double-click on System Properties underneath HOME in the
configuration tree view.
2. The USR-5 System Properties sheet appears. Select the Hard Keys
tab, click on the key as shown left, which you want to assign an IR
code, and proceed with step 4 of How do I assign an IR code to a
button?.
code, and proceed with step 4 of How do I assign an IR code to a
button?.
•
to assign an IR code to the per-device definition of a key:
1. Double-click on the Properties item underneath the device or macro group
in the configuration tree view for which you want to assign an IR code.
2. The Device Properties or Macro Group Properties sheet appears. Select
the Hard Keys tab, click on the key as shown left, which you want to
assign an IR code, and proceed with step 4 of How do I assign an IR
code to a button?.
assign an IR code, and proceed with step 4 of How do I assign an IR
code to a button?.
How do I assign a source switch IR code?
1. Double-click on the Properties item underneath the device or macro group
in the configuration tree view for which you want to assign a source switch
IR code.
IR code.
2. The Device Properties or Macro Group Properties sheet appears. Select
the Action tab and proceed with step 4 of How do I assign an IR code to
a button?.
a button?.