Midland Radio Camcorder XTC-200 Manual Do Utilizador

www.midlandusa.com

5

The XTC-200 was innovatively designed with an identical dual track 

mount system on either side of the camera.  This allows you to mount it 

on either side of a helmet with ease.  In addition, the main mount piece is 

interchangeable and can be moved from the helmet mount to the goggle 

mount.  This eliminates the hassle of having to remount the camera 

every time.

To mount the camera on the main mount piece, slide the camera onto 

the dual track system with the two notches on the mount facing toward the 

back of the camera.

To detach the camera from the main mount, hold the camera with the 

lens facing away from you.  Press down the mount release switch and pull 

the mount toward yourself.

When mounting the camera on a helmet, you must do the following:

1. Consider what you would like to shoot and mount the camera 

accordingly- left side, right side or top.

2. Find a flat surface and ensure the area is clean of dirt and debris.  

Remove the cover of the adhesive pad and adhere to the helmet.

3. Once attached, adjust the camera to be sure you are not filming the 

sky or the ground.

On the bottom of the XTC-200 is a standard thread mount that 

allows the camera to be mounted to a tripod or other fixture with a 1/4-

20 (1/4” diameter, 20 threads per inch) 5/16 deep thread.  The vented 

helmet strap mount is a screw type mount.  To affix the camera, insert 

the screw on the mount into the camera thread and rotate the camera 

clockwise to tighten down onto the screw.

 

When mounting the camera on the handlebars of a bike or with the 

vented helmet strap mount follow these steps:

1. Consider what you would like to shoot and mount 

accordingly.

2. Ensure once attached that the camera is aimed straight

 

and

 

not toward the ground or at the sky.

The Micro SD card can be reformatted while in the camera.  This allows 

you to delete all the videos at one time.  Follow these steps:

1. Move the RECORD switch to the record position.

2. When the battery indicator turns green, press and hold the Micro SD 

card reformat button.

3. Keep holding the Micro SD card reformat button down until the record 

indicator turns off and the Micro SD card indicator begins blinking green.

4. Move the RECORD switch to the off position.

Note: The camera cannot reformat the Micro SD card if the low 

battery light is on.