Laney Amplification Music Mixer Concept 10 Manual Do Utilizador

Concept

 

Concept Manual 

15

PFL

PFL

+10

+10

+6

+6

0dB

0dB

-6

-6

-10

-10

-20

-20

-30

-30

L             R

L             R

TAPE
OUT

TAPE
OUT

MON

MON

AUX 1

AUX 1

TAPE OUT
LEVEL

TAPE OUT
LEVEL

AUX 1
MASTER SEND

AUX 1
MASTER SEND

HEADPHONES

HEADPHONES

PFL ACTIVE

PFL ACTIVE

MON TO
LEFT AMP

MON TO
LEFT AMP

FREQ

FREQ

CUT

CUT

MONITOR

MONITOR

Controls the signal level at the tape out sockets on the facia and the 
line out sockets on the rear.The signal adjusted by this control is the 
signal taken from the master mutes i.e. always the L + R Masters.
The Tape Outs are provided for the connection of 
Tape/DAT/MD/DCC machines for recording purpose but equaly 
could be used for connection to a Hi-Fi amp with Phono /RCA type 
connectors
The Line outs are provided for connection of slave amplifiers should 
additional speakers need to be connected

Controls the overall signal level at the Aux 1 output.
The signal prior to this level control comes from all the Aux 1 
controls on the input channels.The Aux 1 output is a line level 
output suitable for connection to external effects processors.Their 
outputs normaly being returned via the Stereo Auxiliary.

Adjusts the headphone volume level
The signal on the headphones is the same signal being sent to the 
power amplifiers
When PFL is enabled the channel/channels which have been 
PFL'ed signal is present on the headphones.

Indicates that a PFL signal is present in the headphones and on the 
right meter

Normally the signal to the Power amps comes from the L + R 
Masters.If required the Monitor signal can be routed to one of the 
left power amps by enabling the Monitor to Left Amp switch.When 
the Monitor to Left Amp switch is enabled the Master L + R signal is 
summed to together (mono) and is sent to the right power amp.
When this switch is enabled lamps illuminate by the switch and at 
the base of the left meter.
Should the Stereo L+R Master be needed when Monitor to Left 
Amp is enabled it available at the Line Outs and Tape Out.

The MONITOR signal output.The signal here is a line level output 
suitable for connection to an external power amplifier.The signal 
level is controlled by the Monitor fader.

These controls form a notch filter for the reduction of feedback on 
the monitors.  If feedback occurs apply some cut, which should be 
swept up and down using the frequency control until the frequency 
is found, more cut can be applied to reduce feedback further if 
required.

Phono (RCA) sockets are provided for the connection of 
tape / DAT machines for recording.  The signal level is 
controlled by the Line out/Tape out level control.

This is the Aux 1signal output.  Signal is sent here by all the 
Channel Aux 1 controls .The master control for the Aux 1 output 
level  is the Aux 1 Master Send Control.The signal level is a line 
level signal designed for the connection to external effects 
processors

27

28

29

30

31

32

33

34

35

36

10

11

27)

28)

29)

30)

31)

32)

33)

34)

35)
36)