Frigidaire FFQG5000QW Instrução De Instalação

5

Uncoated copper tubing will corrode when subjected 

to natural gas, causing gas leaks. Use ONLY black iron, 

stainless steel, or plastic-coated brass piping for gas 

supply.

CIRCUIT -  Individual, properly polarized and grounded 

15 amp. branch circuit fused with 15 amp. time delay 

fuse or circuit breaker.

POWER SUPPLY - 2-wire, with ground, 120 volt, single 

phase, 60 Hz, Alternating Current. 

POWER SUPPLY CORD - The dryer is equipped with a 120 

volt 3-wire power cord. 

GROUNDING CONNECTION - See “Grounding 

requirements” in Electrical Installation section. 

Grounding type

Grounding type
wa

wall receptacl

ll receptacle

Po

Power cord with

wer cord with

3-prong 

3-prong  gr

grounded plug

ounded plug

1  Installation MUST conform with local codes, or in 

the absence of local codes, with the National Fuel 

Gas Code, ANSI Z223.1 (latest edition). 

2  The gas supply line should be 1/2 inch (1.27 cm) 

pipe. 

3  If codes allow, fl exible metal tubing may be used 

to connect your dryer to the gas supply line. The 

tubing MUST be constructed of stainless steel or 

plastic-coated brass.

  4  The gas supply line MUST have an individual 

shutoff valve installed in accordance with the 

B149.1, Natural Gas and Propane Installation Code.

  5  A 1/8 inch (0.32 cm) N.P.T. plugged tapping, 

accessible for test gauge connection, MUST be 

installed immediately upstream of the gas supply 

connection to the dryer.

  6  The dryer MUST be disconnected from the gas 

supply piping system during any pressure testing 

of the gas supply piping system at test pressures in 

excess of 1/2 psig (3.45 kPa).

  7  The dryer MUST be isolated from the gas supply 

piping system during any pressure testing of the 

gas supply piping system at test pressures equal to 

or less than 1/2 psig (3.45 kPa).

  8  Connections for the gas supply must comply with 

the Standard for Connectors for Gas Appliances, 

ANSI Z21.24.