Dacor RNRP30G Instrução De Instalação

Preparing for Installation

• 

If the gas or electric service provided does not meet the 

product specifications, do not proceed with the installation. 

Call the dealer, the gas supplier or a licensed electrician.

• 

Before installing the range, you must locate and secure the 

anti-tip bracket to the floor.

IMPORTANT: Within the Commonwealth of Massachusetts, this 

appliance must be installed by a licensed plumber or gas fitter.

Unpacking the Range

Unpack the parts box and verify that all required components 

have been provided. If any item is missing or damaged, please 

contact your dealer immediately. Do not install a damaged or 

incomplete appliance.

Installation Instructions

- Grates (2)
- Standard burner caps 

  (3 brass, 3 porcelain)*
- Standard burner rings (3)
- SimmerSear burner caps 

  (1 brass, 1 porcelain)*
- SimmerSear burner ring (1)
- SimmerSear burner head (1)
- GlideRack™ oven racks (2)
- Standard rack (1)

- 5 Knobs (2 MAX GRIDDLE, 

  2 Standard, 1 Oven)
- Anti-tip bracket with screws 

and anchors
- Griddle (1)
- Wok ring (1)
- Broiler pan/grill (1)
- Stainless steel cleaner (1)
- Literature kit (1)

*The range is supplied with two different styles of burner caps 

(brass and porcelain) to suit the customer’s preference. Please 

note that because the burner caps are made of brass, heat will 

distort the brass’ color over time.

Replacing the Backguard

If a different backguard will be used, please assemble it before 

pushing the range into position. 

APB30GLP

1.5-inch high Backguard (Low Profile)

APB30D9

9-inch high Backguard 

Downdraft Installation

If installing a downdraft, install it before moving the range into 

position.
An additional trim kit must be used to unify the downdraft, range, 

and backguard into one piece.

ERV3015

Downdraft

ATKERV-RP30

Trim Kit

Installing Rear Trim 

If installing the range in the self-rimming configuration, or if the 

range will be used with a downdraft, install the rear trim piece  

first.
Remove the existing screws that hold the backguard in place and 

use them to attach the trim piece. (See image below.)

Installing the Anti-Tip Bracket

Locate the anti-tip bracket included in the parts box.

• 

Floor mounting (preferred method).

• 

Wall mounting (alternate method). Use this method if floor 

mounting is not suitable. If the front panel of the range 

(excluding bull nose) is more than 27 inches (68.6 cm) from 

the back wall, or if the flooring is too thick (see Installing 

the Anti-Tip Bracket on the Wall), use the wall mounting 

method.

Sub-floor

Screws attached to 

concrete sub-floor  

(below floor surface).

Anti-tip

Bracket

Floor 

surface

Concrete anchors shown.

Do not use anchors on a wooden sub-floor.