Dacor SGM304BH Guia Do Utilizador
66
Problem
1. Nothing works
1. Nothing works
2. Ignitors do not spark.
3. Sparking, but no flame ignition,
4. Burners ignite, but flame is extremely large,
distorted or yellow.
5. Burner flame goes out at low setting.
6. Ignitors spark continuously after flame
ignition.
Possible Cause
Cooktop is not connected to electrical power.
Cooktop is not connected to electrical power.
Power supply is not energized.
Circuit breaker is tripped.
House fuse is blown.
Power outage in local area.
Gas shut-off valve is on “off” position.
Gas supply is interrupted.
Burner ring ports are clogged.
Burner ports or burner caps are not positioned
properly.
Cookop is being operated on the wrong type of
gas.
Regulator is not installed, is faulty, or is set for
the wrong type of gas.
Low gas supply pressure.
Air intake holes around knobs are obstructed.
Power supply is not grounded.
Power supply polarity is reversed.
Ignitors are wet or dirty.
Remedy
Have cooktop connected to a properly sized
Have cooktop connected to a properly sized
electrical power supply by a qualified electrician.
Have an electrician check power supply,
including the house circuit breaker, wiring and
fuses.
Reset circuit breaker.
Replace house fuse.
Contact power company.
Turn shut-off valve to “on” position.
Contact gas company.
Clean burner ring ports with straightened paper
clip, needle or wire.
Remove and carefully re-install burner rings and
caps.
Ensure that the type of cooktop matches the gas
supply (natural gas of L.P. gas).
Check installation, replace regulator, or set
regulator for proper gas type.
Contact gas company.
Remove obstruction.
Have power supply properly grounded
Have polarity corrected.
Dry or clean ignitors.
Troubleshooting Guide
Unnecessary service calls may be expensive, frustrating and time consuming. Before you call for service, please review the potential problems, possible
causes and remedies shown in the table below.
Troubleshooting