Avanti CK3616 Manual Do Proprietário

• To eliminate the risk of burns or fire by reaching over heated surface units, cabinet storage space

located above the surface units should be avoided. If cabinet storage is to be provided, the risk
can be reduced by installing a range hood that projects horizontally a minimum of 5 inches
beyond the bottom of the cabinets.

• Place your Compact Kitchen on a floor that is strong enough to support it when it is fully loaded

as above picture. To level your Refrigerator, adjust the leveling legs at the bottom of the
refrigerator.

• For satisfactory water drainage of the sink, and proper door functioning, it is important to level the

appliance in both directions, using the leveling legs provided on the bottom of the cabinet for this
purpose.

• Locate the Compact Kitchen away from direct sunlight and sources of heat (heater, radiator,

etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.

• Avoid locating the unit in moist areas.
• Do not under any circumstances cut or remove the third (ground) prong from the power cord of

your refrigerator or burners. Any questions concerning power and/or grounding should be
directed toward a certified electrician or an authorized Avanti Products service center.

• After connecting the appliance to the power supply, allow the Refrigerator to cool down for 2-3

hours before placing items in the compartment.

Electrical Connection

• The appliance must be installed and grounded by a qualified technician in accordance with the

National Electrical Code ANSI/NFPA No. 70 (Latest Edition) and local electrical code
requirements.

• The appliance is designed to be permanently connected with conduit.

• This appliance requires a standard 115/120 Volt AC ~/60Hz electrical power, and connected to

an individual properly grounded branch circuit, protected by a 15 amp circuit breaker or time
delay fuse.

• This unit should be properly grounded for your safety. The range and refrigerator power cords of

the appliance are equipped with a grounded plug which is connected to the grounded permanent
wiring system.

• Do not under any circumstances cut or remove the third ground lead from the AC supply. Any

questions concerning power and/or grounding should be directed toward a certified electrician or
an authorized Avanti Products service center.

• Remove house fuse or open circuit breaker before beginning installation.

• Do not attempt to repair or replace any part of the appliance unless it is specifically

recommended in this manual. All other servicing should be referred to a qualified technician.

• To minimize the possibility of electric shock, disconnect this appliance from the A/C power supply

before attempting any maintenance.

• Do not use extension cords for the connections of the range and refrigerator.

NOTE: Turning the appliance off does not disconnect the appliance from the power supply. We
recommend having a qualified technician service your appliance.

WARNING

The electrical installation shown below must be performed by a qualified and licensed
electrician, following all of the electrical codes and ordinances required by the State.

WARNING

Improper connection of the equipment-grounding can result in the risk of electrical shock. If the
power cord of the range or refrigerator is damaged, have it replaced by an authorized Avanti
Products service center.