Dacor ER30DSCHLPH Instrução De Instalação

Changing the Backguard (models ER30D 

and ER30D-C only)

Models ER30D and ER30D-C come standard with a 3” backguard 

installed. The 6” backguards is optional. Install according to the 

instructions included with the backguard.

Installing the ATK30SR Downdraft Vent Trim 

Kit (model ER30DSR only)

To install the optional downdraft vent with self-rimming model 

ER30DSR, you must install the optional downdraft vent trim kit. 

Install according to the instructions included with the kit.

Installing a Downdraft Vent (Optional)

Install the PRV30 downdraft vent before final installation of the 

range. See the installation instructions included with the downdraft 

vent.
IMPORTANT: The downdraft vent attaches to the narrow back 

portion of the downdraft vent/range cutout. It is self-supporting in 

the cutout and does not actually attach to the range itself.

Installing the Anti-Tip Bracket on the Floor

To perform its intended function, the anti-tip bracket must be 

attached as instructed to the concrete slab or wood sub-floor 

below any floor coverings (including cement board) on top. Do 

not attach the anti-tip bracket directly to floor coverings such as 

ceramic/asphalt tile or linoleum.

1.  Locate the anti-tip bracket included in the parts box.
2.  Install the anti-tip bracket on the floor using the four (4) 

included screws. See the diagram below for location. 

NOTE: 

If the floor is wood, use wood screws instead (not included).

6 5/8” (16.8 cm)

6 3/8” (16.2 cm)

Installation Instructions

B

Right side 

of range

Back of 

range

Top view

Bracket

A

Removing the Oven Door

• 

Do not attempt to disengage the hinge catches with the 

door removed from the oven. The hinge springs could 

release causing personal injury.

• 

Do not lift or carry the oven door by the handle.

To make the range easier to move, remove the door to reduce 

weight.
1.  Open the door to its fully opened position.
2.  Rotate the catch over the retaining arm on each hinge.

3.  Lift the oven door to about a 15° angle from the vertical 

position.

4.  Hold the door with both hands just below the handle and pull 

it away from the oven while continuing to lift.

Catch

Retaining arm