Dacor DHW361 Guia Da Instalação
7
If mounting the hood to drywall:
■ Drill three appropriate sized pilot holes for the
mounting hardware being used. The drywall
mounting hardware must be purchased sepa-
rately.
8. Attach the mounting bracket securely to the wall.
Installing Chimney Mounting
Bracket
1. Locate the chimney mounting bracket and position it
against the ceiling as shown. Center it on the hood
center line.
2. Mark the ceiling and the wall in two places each,
through the holes in the bracket.
3. Drill four 5/16” holes through the four spots marked
on the ceiling and wall.
4. Insert the four of the provided wall anchors into the
four holes on the ceiling and wall.
5. Attach the chimney mounting bracket using four
included 1 1/2” screws.
Hanging the Range Hood
1. Lift the hood up on both sides and put the mounting
hole on the top of the hood over the lip of the mount-
ing bracket. Gently lower it into place.
2. Insert two provided machine screws into the two
holes above the mounting bracket on the range hood.
Tighten the screws until they make contact with the
bracket, then tighten them as necessary to make
minor leveling adjustments to the hood.
3. Insert two machine screws
through the front of the
mounting bracket and
tighten them into place.
4. Install the duct collar or
exhaust cowling on the top
of the hood assembly as
shown below, using the
screws included with the hood.
Installation Instructions
Mounting
bracket
Anchors
Chimney
mounting bracket
Mounting
bracket
Duct Collar Installation -
Models DHW301, DHW361
and DHW421
Exhaust Cowling Installation
- Model DHW482