Monogram ZTD910SFSS Instrução De Instalação

• Remove the three screws from the bottom 

of the drawer edge.

• Remove the four screws on the inside 

of the drawer at the top. Retain all screws.
– Support the drawer front as you remove screws

to prevent the front panel from falling

.

• 

– 

Save these instructions 

for local inspector’s use. Observe all governing
codes and ordinances.

• Note to Installer – Be sure to leave these

instructions with the Consumer.

• Note to Consumer – Keep these instructions 

for future reference.

This kit contains a stainless steel professional style
panel with a handle and a lamp jewel imbedded 
in the bottom right side. The tubular handle from
the original drawer front or a custom handle
cannot be installed on this panel.

IMPORTANT: The warming drawer should be
installed according to the installation instructions
packed with the product. The original drawer front
will be removed and replaced with a custom panel.

IMPORTANT: The drawer must be installed into 
the cabinet before opening the drawer.
• Turn the warming drawer to “OFF.”
• Open the drawer approximately halfway.

• Install the panel assembly to the exposed drawer

front using the original 7 screws.

• Open the carton and remove the panel. 

Remove all protective covering on both sides.

Keep all plastic material

away from babies and small children. Plastic could
pose a choking or suffocation hazard.

• Phillips screwdriver