Monogram ZTD910SFSS Instrução De Instalação

• Phillips screwdriver
• Drill and appropriate bits

(Brad point recommended for drilling 
through wood panels)

• Custom panel
• Custom handle (optional)
• Adhesive recommended for metal to wood
• Adhesive recommended for plastic to wood

• Lamp Jewel
• Metal mounting panel

This kit contains a mounting panel to support a trimless
custom drawer front up to 3/4" thick. The tubular handle
can be reinstalled onto the custom panel with longer
screws (not provided). Or, the original handle can be
replaced with a custom handle of your choice. 
(Handle is not supplied.) Choose a custom handle 
to match or complement cabinetry hardware.

IMPORTANT: The warming drawer should be installed
according to the installation instructions packed with 
the product. The original drawer front will be removed
and replaced with a custom panel.
• Cut edges of the drawer panel will be seen 

and must be finished for best appearance.

• The custom drawer front panel, both raised and flat

design, should be constructed in the same manner 
as typical cabinet doors. 

• Order the custom drawer panel from the cabinet

manufacturer. Be sure to provide the exact dimensions
so that the panel is constructed accurately.

• Order the optional custom handle to complement 

or match surrounding cabinetry handles.

• The custom panel must be sized to fit the dimensions

shown for your model.

• Drill a 5/16" diameter hole through the appearance

side of the panel. This hole will allow the indicator “ON”
light to be visible through the custom panel. The cut
edges will be covered by the overlap of the lamp jewel.
– A Brad point drill bit is recommended.

A = 26-3/4" for 27" Wide Models 
A = 30" for 30" Wide Models

• 

– Save these instructions 

for local inspector’s use. Observe all governing codes 
and ordinances.

• Note to Installer – Be sure to leave these instructions

with the Consumer.

• Note to Consumer – Keep these instructions with your

Owner’s Manual for future reference.

For installation of 27" and 30" wide warming 

drawer custom panel and custom handle.

• Open the drawer fully.
• Turn the warming drawer off.

• Remove the two screws on each side and the one

screw at the bottom of the drawer edge.

• Remove the two screws on the inside of the drawer 

at the top. Retain all screws.
– Support the drawer front as you remove screws 

to prevent the possibility of falling.

A

10-1/2"

1-13/16"

1-3/4"

Drill 5/16" Dia. 
Through Custom 
Panel For Lamp Jewel