Summit RG200W Manual Do Proprietário

19

With proper care, the porcelain enamel

finish on the inside of the oven will stay new-

looking for years.
Let the range cool before cleaning.
We recommend that you wear rubber

gloves when cleaning the range.
Soap and water will normally do the job.

Heavy spattering or spillovers may require

cleaning with a mild abrasive cleaner.

Soapy, wet metal pads may also be used.

Do not allow food spills with a high sugar or

acid content (such as tomatoes, sauerkraut,

fruit juices or pie filling) to remain on the

surface. They may cause a dull spot even

after cleaning.
Household ammonia may make the

cleaning job easier. Place 1/2 cup in a

shallow glass or pottery container in a cold

oven overnight. The ammonia fumes will

help loosen the burned-on grease and food.

Do not spray on the electrical controls

and switches because it could cause a

short circuit and result in sparking or fire.
Do not allow a film from the cleaner to

build up on the temperature sensor-it

could cause the oven to heat improperly.

(The sensor is located at the top of the

oven.) Carefully wipe the sensor clean

after each oven cleaning, being careful

not to move the sensor as a change in its

position could affect how the oven

bakes.
Do not spray any oven cleaner on the

outside of the oven door, handles or any

exterior surface of the oven, wood or

painted surfaces. The cleaner can

damage these surfaces.

Painted surfaces include the sides, control

panel and door. Clean these with soap and

water or a vinegar and water solution.

Do not use commercial oven cleaners,

cleansing powders, steel wool or harsh

abrasives on any painted surface.

Be sure to let the light cover and bulb cool

completely.
To remove the cover:
1. Twist lens counterclockwise about a

quarter turn to remove.

2. Replace bulb with a 40-watt appliance

bulb or two-prong halogen bulb, as

appropriate.

To replace the cover:
1. Line up tabs of lens in front of tabs on

housing and rotate clockwise to engage.

To remove:
1. Hold a hand under the cover so it doesn’t

fall when released. With fingers of the

same hand, firmly push back the wire

cover holder. Lift off the cover.

cool completely.
The oven light bulb is covered with a

removable glass cover that is held in place

with a bail-shaped wire. Remove the oven

door, if desired, to reach cover easily.

2. Do not touch hot bulb with a wet cloth.

Replace bulb with a 40-watt household

appliance bulb.

To replace cover:
1. Place it into the groove of the light

receptacle. Pull the wire forward to the

center of the cover until it snaps into

place. When in place, the wire holds the

cover firmly. Be certain the wire is in the

depression in the center of the cover.

2. Connect electrical power to the range.

Wire cover holder